Temperature Setting - Sanyo MDF-U333 Instruction Manual

TEMPERATURE SETTING

Chamber temperature
Table 1 shows the basic procedure for setting the chamber temperature. Perform key operations in the
sequence indicated in the table. The example in the table is based on the assumption that the desired
o
temperature is -25 C.
Note: The unit is set at the factory that the chamber temperature -30
Table 1. Basic operation sequence (Example: Chamber temperature -25
Description of operation
Connect the power plug to
1
exclusive power supply socket.
(MDF-U537D only)
2 By pressing the compartment select
key, select the top compartment.
3 Press SET key.
Set the temperature to 25 with the
4 digit shift key and the numeric
value shift key.
Press SET key.
5
By pressing the compartment select
key, select the bottom
6
compartment. (MDF-U537D only)
(MDF-U537D only)
Perform the same operation as in the case of steps
7
3 to 5, and set the temperature for the bottom
compartment.
Note:
Although the value of the chamber temperature setting can range from -18
temperature when there is no load is -30
Note that defrosting of this unit is started manually (by pressing the DEF key for about 5 seconds) and
stopped manually.
Key operated
The current chamber temperature is
----
displayed.
Top compartment lamp lights and the
TOP
current chamber temperature of top
BOTTOM
compartment is displayed.
The second digit of the temperature
SET
indicator flashes.
By pressing the key, settable digits
moves.
By pressing the key, the numerical value
of the settable digits increases.
When pressed, the figure of settable
SET
digit increases.
TOP Set temperature is memorized and the
BOTTOM current chamber temperature is displayed.
The chamber temperature setting is stored, and the
current chamber temperature is displayed.
o
C when the external temperature is 30
19
o
C.
o
C)
Indication after operation
o o
C to -40 C, the guaranteed
o
C.