Table of Contents
Advertisement
adapter and network.
* LED(Power/Link Status)
- This LED indicates that power has been applied, and the card is
functional. In normal operation mode with Card Power Management
disabled, it will be steady-on if the card is connected with a AP and
it will be blink slowly if the card in not connected with a AP.
With Card Power Management enabled, it will blink rapidly
(several times per second).
* LED blink slowly.
- The adapter was unable to make contact with the named wireless
network. Verify the ESSID value,in the config.opts file matches
the network name of the access point.
4. MODULE PARAMETERS
==============================================================
irq_list
Select IRQ to use
networkmode Select 802.11 Network type
stationname
Station name
essid
Network name (SSID)
psmode
Power Saving Mode
(! if you enable this mode,there is degradation in the throughput performance.)
wepreq
Enables or diabled encryption of Data.
keyid
Designates which of the keys is to be used for the enciphering of data
that is transmitted by this action.
-1 = auto-assign (default)
1 = Infrastructure Mode(default)
3 = Ad-hoc Mode
Sets the independent network name in ad-hoc mode.
Sets the desired network (desired SSID) to connect
to if using an access point.
default is card-configured
0 = disabled(default)
1 = enabled
0 = disabled(default)
3 = 40 bit WEP
7 = 104(128) bit WEP
0 .. 3(default=0)
In case of 104(128) bit WEP it only supports the keyid 0.
60
Advertisement
Table of Contents
