Maintenance - Panasonic ER-CTN1 Operating Instructions Manual

Maintenance

• Make sure that the main body is turned off.
• Lubricate after cleaning and store the head with one of the
comb attachments attached.
How to clean
► W ith water
To remove light dirt
1. Remove the comb
attachment, run water down
the water inlet. (Fig. 5)
▼
2. Shake up and down several times to remove the water.
▪ Be careful not to hit the appliance on the sink or any other
object while draining the water.
3. Wipe off the water with a dry cloth and dry it well.
▪ It will dry faster with the blade removed.
► W ith the cleaning brush (Fig. 6)
1. Remove the head, comb attachment and blade.
2. Brush off any hair trimmings from the head,comb
attachment and from around the blade.
3. Brush any hair trimmings out from between the stationary
blade and the moving blade while pressing down the
cleaning lever (b) to raise the moving blade.
Notes
• Do not wipe with thinners, benzine, alcohol etc. Doing so
may cause malfunction, or cracking or discoloration of the
parts.
To remove heavy dirt
1. Remove the head, comb
attachment and blade and
rinse them with running water.
▼
Removing and mounting
the blade
To remove the blade, hold the head, place your thumb
against the blades and then push them away from the head.
(Fig. 7‑1)
To mount the blade, fit the mounting hook (d) into the blade
mounting on the head (c) and then push in until you hear a
click. (Fig. 7‑2)
Replacement parts
Replacement part is available at your dealer or Service Centre.
Lubrication oil WES003P
Lubrication
• Apply the lubrication oil to the blade before and after each use.
1
Remove the blade.
2
Apply a drop of the lubrication oil to each indicated point.
(Fig. 8)
3
Attach the blade to the head, turn on the power and
allow it to run for approximately 5 seconds.
9