Hisense RF200D4CSE User's Operation Manual page 9

Installing the water lines
Ice & water dispenser with a filter is one
of the helpful features on your new
appliance. To help promote better health,
the water filter removes unwanted
particles from your water.
Please follow the below instructions
carefully for correct installation.
In order for the ice & water dispenser to
operate properly, a water line is required.
-the maximum inlet water pressure is 862kPa;
-the minimum inlet water pressure is 207kPa.
WARNING!
The water connection must be made
by a qualified plumber. Operation
outside the water pressure range
may cause malfunction, or
and damaging water leaks.
Under normal conditions, a200cc
(5.75 oz.) cup can be filled in about
10 seconds.
If the refrigerator is installed in an area
with low water pressure (below 30psi),
you can install a booster pump to
compensate for the low pressure.
What you need to have before you begin
1. Power drill and 1/4'' drill bit.
2. 1/2'' or adjustable wrench.
3. Flatblade and Philips head screwdrivers.
(1) (2)
Saddle-type one 1/4"
Shut offvalve compression
(1/4" outlet)
(4) (5)
1/4" extension 1 Coupler
tubing
4. You may need to purchase No.1,
No.2 and No.3 parts to complete
this connection. You may find these
items sold as a kit at a local
hardware store.
Connecting to the water supply line
1.
2.
severe
3.
(3)
1 ferrule
(sleeve)
4.
(6)
2 Clips
First, shut off the main water supply.
Using a power drill and a 1/4'' drill bit
drill into the cold-water line and
connect the saddle-type shutoff valve.
Cold water line
Pipe clamp
Shut off Valve
Connect 1/4'' extension tubing to shutoff
valve outlet.
Saddle-Type
Shutoff Valve
Packing Nut
Outllet Valve
Flush the tubing. Turn the main water
supply on and flush out the tubing until
the water is clear. Then, shut the water
off at the water valve after about a quart
of water has flushed through the tubing.
Compression Nut
1/4" Extension
tubing
Ferrule(sleeve)
9