Summary of Contents for Toolots FMJ-1600E-WARM
- Page 1 Ving 63" Entry Level Full Auto Wide Format Heat Assisted Cold Laminator User’s Manual FMJ-1600E-WARM...
-
Page 2: Specifications
I. Description FMJ-1600-E-WARM is a new type of laminator with auto-peeling of liner paper and print take-up function based on the FMJ-1600-II-Warm. It is simple in structure, rational, user-friendly and low in cost. The top and bottom rollers are driven by the motor while the film mandrel and liner paper roll are driven by its own material, that is the straight internal force motion of the printed picture between the main rollers. -
Page 3: Parts Identifications
III. Parts identifications Figure 1 1. Left cabinet 2. Emergent stop 3. Left bracket plate 4. Liner paper roll 5. Film mandrel 6. roller 7. Right bracket plate 8. Right cabinet 9. In-feed table 10. Lift knob 11. prints roll 12. Base plate 13. Pedal switch 14. castor 15. - Page 4 Control Panel： ： Power on/off Press the button to turn on or turn off the machine. When the machine is turned off, the motor and electricity heating will shut down automatically, the roller will be lifted automatically. F/R-Direction Switching Button： Control the rotation direction of the roller.
- Page 5 2） When install the upper and down limit, do not confuse the wire number. 3） Fix the film panel first and then test the button, or else the bulb and cable lines may be damaged. V. Installation and operating 1. Move the machine to its final location, make sure it is free of any damage and ready of all the parts and accessories.
- Page 6 Figure 3 1. Middle bracket of compression on the left 2. Left cabinet 3. Compression spring 4. Upper compression bracket 5. Compression bolt 6. Compression nut The alignment of the main rollers is the crucial factor to ensure the balance of pressure and further affect the quality of lamination and the off-tracking of image.
- Page 7 fewer. Please remove the left cabinet first to avoid excessive work or damage of other parts. As the figure shown above, the middle bracket of the left compression and the upper compression bracket are connected by two bolts. Each bolt has a spring and two screws (see the figure above).
-
Page 8: Lamination Process
by eyes (or measured by a feeler). If it is not even, record the side with small space. Then set the main rollers to idle stroke, cut the main power, open the side board of the wheel carbine, as the figure shows below, screw out the bolt, increase or reduce the number of the insert plates between the lifting plate and the compression plate (the insert plates are supplied as the accessory of the machine) to align the main rollers and then re-install the side board. - Page 9 VI. Safety Cautions： 1. Read this manual carefully before starting the machine. Familiarize yourself thoroughly with the structure, functioning and operation of this machine. Observe all the warning symbols on the machine to prevent accidents. The mains supply must match the type indicated on the machine identification label.
- Page 10 Warranty Card Model Production No. Buyer Purchase time Dealer Notes 1. The above card shall be filled by the dealer and kept by the buyer. Any alternation will invalid the card. 2. The standard warranty period of this machine is one year. You can get free repair service with the warranty card within half a year.
Need help?
Do you have a question about the FMJ-1600E-WARM and is the answer not in the manual?
Questions and answers