Related Manuals for CAN-BUS EMULATOR id-v6
Summary of Contents for CAN-BUS EMULATOR id-v6
- Page 1 USER MANUAL INSTALLATION OF ZETOR ADBLUE EMULATOR www.canbusemulator.com/en +90 530 937 46 36 erenakarsubasi...
- Page 2 INSTALLATION OF ZETOR ADBLUE REMOVAL EMULATOR Emulator all cable must be connect on diagnostic tool socket Red taken from fuse... +15 terminal (You can use fuse F10 for red cable) So we do not remove the fuse because we cut the cable.
- Page 3 INSTALLATION OF ZETOR ADBLUE REMOVAL EMULATOR You need to cut the cable of the 25th and 17th pins in the socket shown in the image.(socket x40) You need to pull the 5A fuse numbered F33. Its location is indicated in the images below.
- Page 4 INSTALLATION OF ZETOR ADBLUE REMOVAL EMULATOR You can cut the cable of pin 11 in the socket and connect the red cable of the emulator to this pin (power +15). Pin 3 to Green wire of Emulator (CAN L) Pin 4 to Yellow wire of Emulator (CAN H) Pin 24 to Black Wire (GND) of Emulator must be connected.
Need help?
Do you have a question about the id-v6 and is the answer not in the manual?
Questions and answers