Table of Contents
Advertisement
7800EMR-ALINK2
User Manual
6.2.8.
AUDIO CHANNEL PAIR FAULTS
The Audio Pair Faults section allows the user to Enable or Disable the Phase Reversal traps and Mono
traps.
Figure 6-16 : Redundancy Mode - VistaLINK
- Audio Channel Pair Faults
®
TDM Channels for Port 1 & Port 2
Show Audio Fault Channels: Allows the user to select which TDM channels to enable traps on.
Apply Button: The apply button applies the channel 1 settings to the rest of the TDM channels.
Trap Enable: Phase Reversal: Allows the user to enable traps to be sent out when a phase reversal fault
is detected on the selected audio pair
Trap Status: Phase Reversal: Status monitor displays fault condition on the audio pairs. Green indicates
no faults while red indicates a triggered fault condition
Trap Enable: Mono: Allows the user to enable traps to be sent out when a fault is detected on a mono
channel on the selected audio pair.
Page - 43
Revision 1.0
Advertisement
Table of Contents
Need help?
Do you have a question about the 7800EMR-ALINK2 and is the answer not in the manual?
Questions and answers