Connecting Your Hdtv; Installing Your Hd Receiver - Philips 502-1040510 User Manual

3.2

Connecting your HDTV

Danger
Risk of electric shock!
Before making any connections, ensure that your
equipment is disconnected from the mains.
1
Aerial wall
socket
Connect the aerial cable (not supplied) from
the aerial wall socket to the Antenna IN
connector on the rear panel of your HD
receiver.
Use the supplied HDMI cable to connect the
HDMI connector on the rear panel of your
HD receiver to the HDMI input connector of
your TV. For the next step, note the chosen
HDMI input of your TV (e.g. 'HDMI 1').
Connect your TV to the mains and select the
correct A/V source on your TV. This should
correspond to the HDMI input connector
to which your HD receiver is connected. If
necessary, refer to your TV's user manual for
instructions.
Notes
• Optionally, you can also use the supplied
RF cable to connect the RF output
connector (labelled To TV/VCR) of your
HD receiver to the RF input connector of
your TV.
• To connect your HD receiver to your
standard-definition TV, see page 29.
10
HD receiver
TV
2
HDMI
3.3

Installing your HD receiver

Before you start the installation, make sure you
have made all the required connections.
Connect the 12 V power supply unit to the
12 V input connector on the rear panel of
your HD receiver.
Connect the mains plug to the mains wall socket.
Ensure that the ON/OFF switch on the
rear panel of your HD receiver is switched
on (is in the '1' position).
Your HD receiver displays a welcome
message after a few seconds.
Mains wall
socket
Press the green button to start the
installation.
The Antenna powering menu appears.
Let the Antenna powering setting be Off
unless you use an indoor antenna that can
be powered by the coaxial cable connected
to the Antenna IN socket of your HD
receiver (see note).
Note
Your HD receiver can only deliver 50 mA
current under 5 V, so refer to your indoor
antenna's user manual to check if its power
requirement fits the capability of your HD
receiver.
Getting started