STERNO HOME GL40736 Quick Start Manual

STERNO HOME GL40736 Quick Start Manual

Indoor - outdoor stringlight

Advertisement

BATTERY INSTALLATION (ill. 1)
Your stringlight requires three (3) AA alkaline 1.5V batteries (not included) to achieve
maximum battery life.
Clean the battery contacts and also those of the device prior to battery installation.
1. To open battery compartment, push clip up.
2. Insert three (3) AA alkaline batteries into the compartment in the proper polarity as shown.
3. Close the battery compartment.
HOW TO OPERATE THE STRINGLIGHT USING BATTERY BOX (ill. 2)
Press the button on the battery box to select from 8 pre-programmed sequences.
HOW TO OPERATE THE STRINGLIGHT AND TIMER USING
REMOTE CONTROL (ill. 3)
"TIMER" MODE"
Push "TIMER" button to activate the timer. The stringlight will automatically turn off after
6 hours.
If the ON or OFF button is pressed, the timer function will be reset and the lights will
not turn on at the desired time. To re-start the timer function, press the timer button at the
desired time to re-initiate this setting.
Note: If the "ON" or "OFF" button on either remote or battery box is pressed, the timer
function will be reset and the lights will not turn on at the desired time.
"ON/OFF" MODE
1. Push the "ON" button to turn stringlight on.
2. Choose a sequence mode by pressing button 1 to 8.
3. Push the "+" or "–" button to adjust the light intensity
4. Push the "OFF" button to turn stringlight off.
FIND A LOCATION FOR THE BATTERY BOX (ill. 4)
Note: Do not place the controller directly on the ground as water could penetrate if it is
soaking in water.
1. The controller is designed for outdoor use and is weather resistant.
2. Make sure that the controller can be installed in a location that will allow a direct
line of sight with the remote to operate properly.
3. Any objects between the front of the control box and the remote control will
reduce the range.
a
4. Mount the controller in the best location and do not place it close to the electrical outlet.
8 METRES/26 FEET
M A X I M U M
4 MÈTRES
M A X I M U M
READ, FOLLOW AND SAVE THESE INSTRUCTIONS
MODEL #GL40736
Indoor - Outdoor Stringlight
Battery box
CUSTOMER SERVICE
1-888-867-6095 • customerservice@sternohome.com • www.sternohome.com
Button
Ill. 2
r
Bushes
Ill. 1
Ill. 3
Ill. 4
Battery box
5021-GL40736-EN_120618

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the GL40736 and is the answer not in the manual?

Questions and answers

Summary of Contents for STERNO HOME GL40736

  • Page 1 READ, FOLLOW AND SAVE THESE INSTRUCTIONS MODEL #GL40736 Indoor - Outdoor Stringlight BATTERY INSTALLATION (ill. 1) Ill. 1 Your stringlight requires three (3) AA alkaline 1.5V batteries (not included) to achieve maximum battery life. Clean the battery contacts and also those of the device prior to battery installation.
  • Page 2 REMOTE CONTROL BATTERY REPLACEMENT (ill. 5) Note: The remote control operates with one coin cell battery CR2025 (included) or CR2032. ill. 5 1. Push tab while pulling out battery compartment as shown. 2. Remove used battery, clean the battery contacts and replace with either a new CR2025 or CR2032 3V Lithium battery in proper polarity as indicated.

Table of Contents