Download Print this page
Sealey LED450UV Instructions

Sealey LED450UV Instructions

Penlight torch with uv 5w cob & 3w smd led with laser pointer rechargeable

Advertisement

Quick Links

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instructions
AVOID DIRECT EYE EXPOSURE
1. SAFETY
1.1.
GENERAL SAFETY
Ensure the penlight torch is fully charged before initial use.
9
DO NOT charge in damp conditions.
8
DO NOT turn the penlight torch on when it is being charged.
8
DO NOT shine the penlight torch beam into yours, another persons or an animals eyes.
8
DO NOT allow children to use the penlight torch.
8
DO NOT handle or move the penlight torch while it is being charged.
8
DO NOT use the penlight torch if you suspect that the battery or the penlight casing is damaged.
8
DO NOT leave battery in a discharged state. Recharge the battery immediately.
8
Before storage, fully recharge the battery.
9
Recharge the battery at least every six months of non-use.
9
Disconnect the USB-C cable after charging.
9
DO NOT attempt to open, disassemble, modify or service the battery.
8
DO NOT crush, puncture or dispose of in fire or water.
8
Recycle or dispose of penlight torch as stipulated by local regulation.
9
WARNING! Keep away from extreme temperatures especially heat.
1.2.
LASER SAFETY
WARNING! Children under six years old should not use this product without adult supervision.
WARNING! DO NOT deliberately look or stare into the laser beam. Permanent eye damage could result.
DO NOT shine the laser beam into another persons or an animals eyes.
8
WARNING! If the laser beam is obstructed by another person during use, switch off immediately.
DO NOT point the laser beam at aircraft or a vehicle that is in motion.
8
WARNING! Be aware that a reflected laser beam from mirrors or other shiny surfaces can be as hazardous as direct eye exposure.
WARNING! The warnings, cautions and instructions in this manual cannot cover all possible conditions and situations that may
occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product,
but must be applied by the operator.
2. INTRODUCTION
Professional aluminium design that produces an ultraviolet light for fault finding with fluorescent dyes used in leak detection. 5W COB side
floodlight producing 450 lumens. Also featuring a 3W SMD tail light and type 3R laser. Rechargeable 800mAh Li-ion battery with a type C
charging cable. A 120 degrees rotating metal clip with a strong magnet for easy hands-free use. Also includes dimming switch.
3. SPECIFICATION
Model No: ............................................................ LED450UV
Battery Type: .....................................................3.7V 800mAh
Input (USB Type-C): ........................................... 5V (dc) 0.5A
Charge Time: .................................................................. 3hrs
Work Light Source: .................................................. 5W COB
Work Light Brightness: .........................................450 lumens
Work Light Runtime:.......................................................2.5hr
Torch Source: ...........................................................3W SMD
Torch Brightness: .................................................140 lumens
Torch Runtime: ...............................................................2.5hr
Product Dimensions (L x D x W): .... 165mm x 23mm x 19mm
LED Type: ..............................................5W COB + 3W SMD
4. OPERATION
4.1.
CHARGING THE PENLIGHT TORCH
4.1.1.
Lift up and rotate the charging port cover (fig 1) and insert the USB-C cable into the charging port (fig 1).
4.1.2.
Insert the other end into either a USB wall charger, a car accessory charger or the USB port on a computer (non supplied).
© Jack Sealey Limited
PENLIGHT TORCH WITH UV 5W COB
& 3W SMD LED WITH LASER POINTER
RECHARGEABLE
MODEL NO:
LASER RADIATION
Original Language Version
LED450UV
365nm UV Light Source: .......................................... UV Light
365nm UV Light Runtime: .................................................4hr
Laser Light Source: ................................................Red Laser
Laser Light Runtime: ................................................... >20hrs
LED450UV Issue 1 28/04/22

Advertisement

loading

Summary of Contents for Sealey LED450UV

  • Page 1 LED450UV MODEL NO: Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance. IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED.
  • Page 2 BATTERY REMOVAL Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of products containing batteries (as defined within these regulations), that they are registered with Valpak’s registered compliance scheme. Jack Sealey Ltd’s Batteries Producer Registration Number (BPRN) is BPRN00705.