SFP Modules Setup Options Set up your Fortinet device locally. Installation Cage Socket Port 1 Management Computer Ethernet Cable Note: For static IP configuration, use 192.168.1.2 with subnet mask 255.255.255.0 Removal Cage Socket Speed (default): 9600 Data bits: Stop bits:...
5. Check that the inner rails are properly connected to the device and that the outer rails are securely attached to the rack. Caution: Electrostatic discharge (ESD) can damage your Fortinet equipment. 6. Align the inner rails with the outer rails then slide the device onto the rails. Ensure that even pressure is applied to both sides of the device while doing this.
Desktop Mount 1.5in 1.5in 1.5in 1.5in Note: Place the device on a flat, clean and stable surface.
Page 7
FAC-3000F - Front POWER Ports 5 & 6 (SFP+) Top LED Bottom LED Green: Device is on Amber: Connected at 10Gbps Off: Device is off Flashing Amber: Transmitting & receiving data SFP+ Ports Off: No link established HDD (not in use) STATUS (not in use) Hard Disk Status Hard Disk Power (Left side LED)
Page 8
FAC-3000F - Rear Grounding Screws provide additional grounding Power Switch On/Off toggle Redundant Hot Swappable Power Supplies (x2) 100-127/200-240VAC, 50/60Hz, 10/5A LED Indicators Green: PSU operating normally Flashing Green: PSU in standby Amber: Critical event or power lost; secondary PSU powering the device Flashing Amber: PSU warning event;...
Page 9
限用物質含有情況表 (RoHS Table) 請到以下 網址下載: socket outlet could place hazardous voltage on accessible metal parts. https://www.fortinet.com/bsmi Avertissement: Équipement de classe I. Cet équipement doit être mis à la terre. La fiche d’alimentation doit être connectée à une prise de terre correctement câblée.
Need help?
Do you have a question about the FortiAuthenticator 3000F and is the answer not in the manual?
Questions and answers