Ethernet, Ip Address Set-Up - Johnson Controls SABROE UniSAB III Engineering Manual

UniSAB III (boot) and communication set-up
8.4.2

Ethernet, IP address set-up

Press F2 /Ethernet for information about Ethernet port set-up.
F1
To change the Ethernet set-up, press /Modify.
To change the IP addresses, press .
Change the number using the F keys or the arrow keys, and press .
In the same way you can set the appropriate subnet mask and gateway address. The subnet mask must
be the exact same on all UniSAB III units and possible PC/routers on the LAN (Ethernet) network.
The gateway address must be set to an IP address which matches the address of the LAN network, i.e.
the PC/router on the first three segments.
The DNS server address must be set to an IP address which matches the address of an optional DNS
server.
It is not necessary to change the broadcast address. When all settings are OK press and /Escape.
UniSAB III will now be restarted with the new settings.
Engineering manual - UniSAB III 1.10.8
001930 en 2021.06 281/346