Maintenance And Servicing; Cleaning The Press And The Ram - Schmidt TorquePress 520 Original Assembly Instructions

4 Maintenance and servicing

Maintenance intervals
Press
Ram
16
4 Maintenance and servicing
CAUTION
Safety instructions
 The press must only be serviced by a skilled person.
 Any work on the electrical equipment of the press must be carried out
only by trained electricians or by specially instructed persons under the
control and supervision of a trained electrician and in accordance with
the applicable electrical engineering rules and regulations.
 All spare parts must comply with the technical requirements specified
by SCHMIDT Technology. This is always guaranteed in the case of
original spare parts.
Unless expressly described otherwise, do not start with the maintenance and
servicing work until

the press has been disconnected from the power/voltage supply,

the press system has been switched off and secured against being
switched on again,

the dangerous movements have come to a standstill,

unauthorized, inadvertent
movements as a result of stored energy is prevented.
Interval
Every week
(every 50 operating hours)
Every year
(every 3,000 operating hours)
Automatically
(suggested by the control)
Automatically
(suggested by the control)
Further information about the necessary activities you get in the individual
chapters.
4.1

Cleaning the press and the ram

CAUTION
In any case do not use any solvent based cleaners.
 Clean the press with a lightly oiled cloth.
 Move the ram to the BDC position.
or unexpected starting
Activity
see chapter "4.1 Cleaning the press and the ram"
see chapter "4.2 Adjusting the force measurement"
see chapter "4.3 Lubricating the spindle"
see chapter "4.4 Filling the grease reservoir"
TorquePress 520-560 – V2.1
®
SCHMIDT
of dangerous