Table of Contents
Advertisement
Chapter 3 - How to...
3. Switch on the scan head.
If the scan head is in standby mode the status indicator will be blue. Press the blue status
l
indicator to switch on the scan head.
If the scan head has been shut down the status indicator will be off. Press the power switch on
l
the back of the scan head to the on ( ) position. There will be a short delay while the device
starts up.
The status lights on the front of the scan head cover will flicker and then settle on the green
l
light.
The touch screen powers up.
l
4. The scan head takes less than five minutes to start up, please wait for the scan head to start up. The
following happens during start up:
The system will run a series of self-tests during this time.
l
The status indicator will be white while the self-tests are running.
l
The imaging procedures will be available when the self-tests have completed and the status
l
indicator is green.
5. Enter your username and password on the touch screen when prompted. Usernames and passwords
are assigned by your System Administrator, see Managing user details on page 49 (all passwords are
case sensitive).
Note
If there is a network error when starting the scan head it is likely that there is a temporary problem
l
with the image server. You can attempt to clear problems by restarting the image server, see How
do I restart the image server? on page 58.
You will be unable to capture images if the self-tests have not been successful. Please restart the
l
scan head. If the problem persists please contact your Optos representative, see Contact us on
page 67.
3.1.1.3 Switch on browser-based review clients
Captured images can be reviewed using the
access the patient details and images stored on the system.
Browser-based review clients have to be on the same network as the scan head and the image server.
Usually, browser-based review clients have been logged off at the end of each day. To login to a browser-
based review client:
1. Press
[Ctrl]+[Alt]+[Del]
2. Type your username and password. Select OK.
3. Connect to the
OptosAdvance
4. Enter your username and password when prompted. Usernames and passwords are assigned by your
System Administrator, see Managing user details on page 49 (all passwords are case sensitive).
3.1.2 Use standby mode at the end of each day
The scan head must be put into standby mode at the end of each working day.
Page 30 of 72
English
OptosAdvance
to display the
Unlock Computer
URL from your browser.
software. You need to login to
dialog box.
Copyright 2019, Optos plc. All rights reserved.
OptosAdvance
to
Part Number: G110230/1ENG
Advertisement
Table of Contents
Need help?
Do you have a question about the P200T E Series and is the answer not in the manual?
Questions and answers