Sfp Fiber Module Installation And Removal; Fiber Input And Output Connections; Figure 4-1: 3405T, 3405R, 3405T13-R, And 3405Oo13-Da4 Evertz; Figure 4-2: 3405Frs-Bnc Front View With Fiber Inputs And Outputs - evertz 3405 Manual

3405 Frame Manual
3405FRS-BNC Fiber Optic SFP Frame
4.

SFP FIBER MODULE INSTALLATION AND REMOVAL

Figure 4-1 depicts any one of the following Evertz
3405R-2R, 3405OO13-DA4, and 3405OOxx-DA4.

Figure 4-1: 3405T, 3405R, 3405T13-R, and 3405OO13-DA4 Evertz

4.1.

FIBER INPUT AND OUTPUT CONNECTIONS

These connections are made using standard LC fiber connector ends, single mode terminated on
transmitting ends and multimode terminated on receiving ends. There are a total of 4 dual SFP slots,
allowing for a mix of 8 fiber inputs or outputs on the 3405FRS-BNC front panel. A high quality fiber cable
such as Corning SMF-28 or suitable equivalents should be used for optimum performance. Compatible
SFP modules currently come in four configurations: dual transmitters, dual receivers, reclocking
transmitter, and reclocking receiver.

Figure 4-2: 3405FRS-BNC Front View with Fiber Inputs and Outputs

Unpopulated SFP slots will remain inactive until the appropriate SFP is installed. Please ensure flat or
ultra flat polished fiber LC connectors are used for the SFPs.

NOTE: Channels A and B on the front of the 3405FRS-BNC frame correspond to
channels A and B on the rear of the frame (Figure 5-1).
Page - 8
SFP modules: 3405T13-2, 3405Txx/yy-2, 3405R-2,
®
Revision 1.1

SFP Modules

®