Connections (Without Scart Leads) - Panasonic DMR E50 Operating Instructions Manual

If you do not have any scart leads and your TV is not Q Link type, you can connect your DVD Recorder to a TV and Satellite Receiver using
RF leads.
Using this connection method may however be difficult to obtain a clear picture from the Satellite Receiver. For this reason it is not
recommended for inexperienced users.
(See preferred connection on page 12.)
Satellite Receiver (not supplied)
To AC Mains socket
AC Input socket
AC Mains lead (supplied)
1
Connect the aerial to the aerial input socket of the
Satellite Receiver.
≥If you do not have a Satellite Receiver, connect the aerial to
the RF Input socket of the DVD Recorder and go to step 3.
2
Connect the aerial from Satellite Receiver to the RF
Input socket.
RF IN
This unit
3
Connect the RF Output socket to the TV aerial
socket.
RF OUT
This unit
R - AUDIO - L
OPTICAL
DIGITAL AUDIO OUT
(PCM/BIT STREAM) R - AUDIO - L
4
Plug the TV, DVD Recorder and Satellite Receiver
into the mains as shown at top of the page.

Connections (without Scart leads)

4
R - AUDIO - L VIDEO S-VIDEO
AV1 (TV)
OPTICAL
DIGITAL AUDIO OUT
AV2 (DECODER/EXT)
(PCM/BIT STREAM) R - AUDIO - L VIDEO S-VIDEO
4
Satellite Receiver
Satellite Receiver
RF IN
R - AUDIO - L VIDEO S-VIDEO
AV1 (TV)
OPTICAL
RF OUT
DIGITAL AUDIO OUT
AV2 (DECODER/EXT)
(PCM/BIT STREAM) R - AUDIO - L VIDEO S-VIDEO
TV
RF IN
VIDEO S-VIDEO
AV1 (TV)
RF OUT
AV2 (DECODER/EXT)
VIDEO S-VIDEO
Aerial Input socket
Aerial
(not supplied)
Aerial Output socket
RF lead
(not supplied)
RF Input socket
RF IN
Aerial Input
socket
RF OUT
RF Output socket
3
RF lead (supplied)
≥Must be connected to
watch TV channels.
Note
≥If you have an analogue satellite receiver, select [SKY ONE] or
[SKY NEWS] on the receiver before starting Auto Setup.
After Auto Setup is complete, the satellite position will be shown
as [SAT] in the channel listing to denote programmes from the
satellite receiver.
≥If you have a digital satellite receiver, you can start Auto Setup
with the receiver set to any channel.
We recommend to manually name the [SAT] position after Auto
Setup is complete. (See page 65.)
13
1
2
TV (not supplied)
4
To AC Mains socket