Related Manuals for VEVOR X-150
Summary of Contents for VEVOR X-150
- Page 1 Thank you for selecting our Slush Machine Please read this manual carefully before using to ensure safe and proper operation, and please keep it properly . User's Manual for the Slush Machine...
- Page 2 Table of Contents 1. Product Description 5. Cleaning and Maintenance 1.1. Product use 5.1. Empty the Bowl 1.2. Main Parts 5.2. Disassemble the Push Faucet 1.3. Technical Parameters 5.3. Remove the Bowl and Lid 1.4. Control Panel Description and Function 5.4.
- Page 3 1.4Control Panel Description and Function 1.4.2 Introduction of Function and Set ( Model:X-150) 1. Product Description Parameters 1.4.1 Panel Diagram: 1. Press “Mixing key”, turn on mixing 1.1. Product Usage function, mixing light is on. Press Factory Meaning Code Model This machine is suitable for making slush “Mixing key”...
- Page 4 6.Hold down "Set key" and "temp setting press the Slush key again to close the slush Press “Right Mixing Key” again to turn off key(+)" to change the value. The system key" for 5 seconds at the same time to function.
- Page 5 3. The power cord and the plug size shall All operations described in Chapter 4 must squeezed * Before using the machine for the first be in compliance with the parameters on be carried out by professionals in charge of time, all the parts must be cleaned, and 3) The machine should be placed in a cool machine...
- Page 6 2) Before making slush for the customer, machine if there is material or other liquid Warning: please use a small amount of product to in the bowl 1) Please do not open the lid forcibly. try first. 6.3 Remove the bowl and lid 2) Never add liquid higher than 25 degrees 5.5 Emergency Situations Remove each bowl to ensure that the...
- Page 7 container (2% sodium hypochlorite mixed with the machine with water) 4. Allow operation for 30 minutes 2. Thoroughly wash the bowl, lid and 5. Rinse twice or more. Only the bottom of evaporator with a soaked sponge. the lid needs to be wiped with clean water 3.
- Page 8 Important note: Always check the integrity of the seal ring. If the seal ring is broken, it 7. Wiring diagram should be replaced with a new one Use the supplied Vaseline to lubricate the seal ring in the illustrated area. Install the mixer shaft as shown;...
Need help?
Do you have a question about the X-150 and is the answer not in the manual?
Questions and answers