Panasonic 3000 Operating Instructions Manual page 35

Programming or Retrieving Parameters via Email
Explanation of Contents
(1) To
From
Subject
(2) @sender to @end
(3) @select-domain to @end
(4) @relay-domain to @end
(5) @system to @end
(6)
: The DP-2500/3000's email address
: This field is normally not visible when creating new email message(s). It is your default
email address for retrieving the Internet Parameters and for error message notification.
(Can be programmed with the configuration tool of your email program.)
: To Store data, type: #set parameters(password)#
: Defines the Sender information to be set in section (2) between @sender to @end block.
Edit, Delete or Register up to 24 User Names and their Email Addresses for the Sender
Selection feature (see page 83).
Separate each data field with a semicolon (;). (If the remaining fields are to remain blank,
insert a semicolon (;) for each blank field).
The data string for each Sender Selection should be defined within a single line. The
syntax is:
<Sender Selection Number>;<User Name>;<Email Address>
(a) 01 to 24: Indicates the Sender Selection Numbers
(b) User Name (25-characters maximum)
(c) Email Address (60-characters maximum)
: Defines the Selectable Domains to be set in section (3) between @select-domain to
@end block. Register up to 10 alternate Domain Names that can be selected during
manual email addressing by pressing the Domain Key
The syntax is: <Number>;<Domain>
: Defines the Domain Names to be set in section (4) between @domain to @end block.
Register up to 10 the Domain Names that have been authorized to access your Internet
Fax for Relayed XMT Request. (30-characters maximum)
: Defines the Internet Parameters to be set in section (5) between @system to @end
block. Register the following Internet Parameters.
(a) Default Domain (30-characters maximum).
The syntax is: domain; <Default domain name>
(b) Manager's Email Address (60-characters maximum).
The syntax is: manager; <Manager's Email Address>
(c) Relay XMT Password (10-characters maximum. The syntax is: relay; <Relay XMT
Password>. Quotation marks " " enclosing the password, are required, as shown in
the example above).
(d) Remote Password (10-characters maximum. The syntax is: remote; <Remote
Password>. Quotation marks " " enclosing the password, are required, as shown in
the example above).
(Notice that for the above example, we have changed the Manager's Email Address,
Relay XMT Password and the Remote Password).
: This header must be deleted before the email is sent to the DP-2500/3000 for
reprogramming of Internet Parameters.
The information following the "#" sign is ignored by the DP-2500/3000, therefore, you can
leave it as is or delete it if you wish.
INSTALLING YOUR MACHINE
. (30-characters maximum)
35