Av Receiver Tx-Ds; Connecting An Equalizer; Connecting The Power - Onkyo TX-DS676 Instruction Manual

Connecting an equalizer

TX-DS777
R L R L V S
DIGITAL INPUT
AMP IN
OUT
FRONT
COAXIAL
ANTENNA
1 VIDEO-1
PRE OUT
IN
FRONT
COAXIAL
AM
2
SUB
WOOFER
OUT
OPTICAL
1
CENTER
VIDEO-2
IN
SURROUND
OPTICAL
2 FM
75
VIDEO-3
FRONT IN
OPTICAL
SUB
DVD
WOOFER
DIGITAL OUTPUT IN
CENTER
SURROUND
(REC) MONITOR
MULTI CHANNEL
INPUT OUT OUT
R L
TAPE V S
CD IN
(PLAY)
R L
GMD
VIDEO
PHONO
S VIDEO
OSD SELECTOR
R L
R L
AMP IN
FRONT
PRE OUT
FRONT

Connecting the power

3. STANDBY/ON button
STANDBY indicator
2. POWER switch
Display
FM MUTE/
DIMMER MODE
STANDBY/ON
STAND-BY
POWER
ON OFF
LISTENING MODE
A SPEAKERS B
DISPLAY DIRECT STEREO
SURROUND
PHONES
MUL TI CH INPUT
DVD VIDEO-1 VIDEO-2 VIDEO-3 VIDEO-4
2. POWER STNBY
button
2. POWER ON
button
1. MODE AUDIO
button
SURROUND SPEAKERS FRONT SPEAKERS A
R L R L
CENTER
SPEAKER
R L
AC OUTLETS
FRONT SPEAKERS B SWITCHED
TOTAL 100W MAX.
W
TX-DS777
REMOTE
CONTROL
Output jack
Input jack
Input jack
Epualizer
MASTER VOLUME
CHARACTER/ SP/SYS AUDIO BASS/
DOWN TUNING UP MEMORY SETUP ADJUSTMENT TREBLE
MODE
PRESET/MODE ADJ
PUSH TO ENTER
DIGITAL/
ANALOG
/DTS THX DSP REC OUT CH LEVEL
MODE
VIDEO / 4 VIDEO CAM INPUT
TAPE FM AM PHONO C D
S VIDEO VIDEO L AUDIO R(MONO)
AV RECEIVER TX-DS 777
(TX-DS777)
The AMP IN and the PREOUT FRONT connectors are attached
with jumper plugs. When connecting an equalizer, remove these
jumper plugs before connecting the audio connection cables.
1. Remove the jumper plugs.
See "Connecting power amplifiers."
2. Connect an equalizer.
1. To wall outlet
Connecting the power
• Before you plug in the receiver, confirm that all connections
have been made properly.
• Turning on this receiver's power may cause a momentary power
surge, which might interfere with other electrical equipment,
such as computers. If this happens, use a wall outlet on a differ-
ent circuit.
1. Plug the power cord into an AC wall outlet.
2. Press the POWER switch to set the receiver to Standby
mode.
The STANDBY indicator will light up.
3. Press the STANDBY/ON button to turn on the receiver. The
display will light up and the STANDBY indicator will be
turned off.
If you press the STANDBY/ON button, the receiver returns to
Standby mode.
Turning the power on from the remote controller:
1. Press the MODE AUDIO button.
2. Press the POWER ON button to turn on the power to the
receiver, or press the POWER STNBY button to set the re-
ceiver in standby mode.
• You cannot use the remote controller if the POWER switch on
the receiver is set to OFF.
• Set the volume level to minimum before you turn off the power
to the receiver.
13