Wings - Airigami PAPIER AVION BOEING 737-600 Instructions Manual

WINGS

4
Cut out the objects
in WINGS (or
"WG") section
objects.
Insert the completed Wing Fairings
(WF0 through WF9) into the
appropriate slots.
Insert port-side Wing Fairings (E) into
the port-side wing into the (D) slots.
Paper-based scale model design system Copyright © 2001-2019 — James Messner / Papier Avion and Airigami
Cut out the slots for the engines, wing
fairings, and engines. Note that the
precise placement and number of the
slots will vary by aircraft type. For (A)
and (C) slots, simply cut inwards from
the outside and remove the yellow
sections.
Insert the completed Wing Fairings
(WF0 through WF9) into the
appropriate slots.
Insert port-side Wing Fairings (E) into
the port-side wing into the (D) slots.
For (B) slots, either use a razor or
cut from the inside, remove the
yellow sections, and then repair the
cut wing sections with tape on the
interior.
Non-printed Side
Once completed, set the objects aside until they are needed at a later stage.
Printed Side
8