Sony BKM-35H Installation Manual page 11

8
Place the monitor on the BKM-15R and the base
frames so that the four legs of the monitor can go into
the four holes on the top of the BKM-15R and the base
frames.
Note
Before going to Step 9, make sure that four legs are
properly set in the corresponding holes as illustrated.
9
Set two inner plates to the two side covers (long or
short). Connect the monitor and the BKM-15R using
the side covers. Secure the side covers to the BKM-
15R and to the lower sides of the monitor using screws
A (4×20 mm) and screws B (4×8 mm) as illustrated.
If you install the monitor on a desk:
Use the long side covers.
Screw B
Screw A
Screw
A
If you mount the monitor on a rack:
Use the short side covers.
Screw B
Screw A
Note
Be sure to attach the side covers securely to both the
monitor and the BKM-15R.
10
Attach the two joint covers to the monitor and the
BKM-15R using the screws C (4×8 mm).
Inner plate
DC 5V OUT
and LAN (10/
100)
connectors
Screw C
Long side cover
11
Plug the connecting cable into the DC 5V OUT and
LAN(10/100) connectors on the rear panel of the
Screw B
monitor.
Screw A
Note
Screw
A
Be sure to plug the male connector of the cable into the
DC 5V OUT connector on the monitor.
Joint covers
Plug the male
connector into
the DC 5V OUT
on the monitor.
Inner plate
Short side
cover
Screw B
Screw A
Screw C
LAN (10/100)
connector
DC 5V OUT
connector
11
Assembly