Mizu Drift MK2 Installation Instructions

Mizu Drift MK2 Heated

Towel Rail x1

Waterproof Connector x2

Screw x4

Leg Dressing x4

Transformer x1

Tools Required

Level

Drill & Drill Bit Ø8mm

Electrical connections must be installed to the requirements of AS/NZS 3000 by a qualified

electrician. Modifying the product outside of the information in the installation is not recommended

and will not be covered under warranty.

Mizu Drift MK2 Heated Towel Rail

Low Voltage 24V

Non-Electrical Legs x3

Allen Key x2

Philips Head

Screwdriver

Electrical Legs x1

Fastener x5

Screw Anchor x4

Wall Bracket x3

Marker

Flat Head Screwdriver

Flat Head Grub Screw

Pointed Grub Screw x4

Electrical Wall Bracket

Wall mount x4

Tape Measure

Allen Key

Page 01

of 05

Table of Contents

Do you have a question about the Drift MK2 and is the answer not in the manual?

Page 1 Mizu Drift MK2 Heated Towel Rail Low Voltage 24V Mizu Drift MK2 Heated Flat Head Grub Screw Towel Rail x1 Waterproof Connector x2 Non-Electrical Legs x3 Electrical Legs x1 Fastener x5 Pointed Grub Screw x4 Electrical Wall Bracket Screw x4...
Page 2 Pre-Installation Instructions Review instructions carefully before installation. Ÿ Installation should be completed by a suitably qualified person. Ÿ Please dispose of packaging in a responsible manner. Ÿ Warning This product must be installed by a qualified electrician in accordance with AS/NZS 3000 wiring rules. Switch off the electrical supply at the mains before installation and maintenance.
Page 3 Operation & Maintenance After installation, connect the electric power and turn on the wall switch. The towel warmer will start to work. Ÿ Turn off the power wall switch when towel warmer is not in use. Ÿ Clean the towel warmer with a soft dry towel. Ÿ...
Page 4 Wall Preparation Ÿ Note: Heated towel rails may be fixed to ANY type of wall, Transformer Ÿ timber stud, steel stud or masonry (solid or cavity). Stud walls (timber or steel) require timber noggins at the correct Fixed 12V Wiring Ÿ...
Page 5 Installation - 3 Ÿ Ÿ Push all Leg Dressing into rail Legs before connecting wires or securing rail Legs. Follow the wiring configuration as illustrated. Ÿ Note: DO NOT strip ends bare. Insert electrical wiring into the Waterproof Connector socket. Ÿ...