Related Manuals for Nostalgia Electrics Kegorator KRS-2150
Summary of Contents for Nostalgia Electrics Kegorator KRS-2150
- Page 1 All products are trademarks of Nostalgia Products Group, LLC. Worldwide design & utility patented or patents pending. © 2010 Nostalgia Products Group, LLC. www.nostalgia electrics.com (rev. 05/12/10)
- Page 2 Kegorator™ Instruction Manual...
-
Page 4: Table Of Contents
CONTENTS IMPORTANT PRECAUTIONS IMPORTANT SAFEGUARDS ....3 INTRODUCTION ......5 PARTS &... -
Page 5: Important Precautions
IMPORTANT PRECAUTIONS NEVER use an abrasive sponge, cloth or scouring pad on this appliance. NEVER leave appliance unattended while in use. Unplug unit from outlet when not in use and during cleaning. DO NOT operate this appliance with a damaged cord or plug, or if the appliance ever malfunctions. - Page 6 Do not operate this appliance when parts are missing or broken. Do not use this appliance for commercial use. This appliance is designed for indoor use only and should not be used outdoors. To reduce is the risk of injury, do not allow children to play in or on the appliance. Close supervision is necessary when the appliance is used near children.
-
Page 7: Introduction
INTRODUCTION To ensure that your KEGORATOR™ works to the maximum efficiency for which it was designed, keep it in a location where there is proper air circulation and electrical outlets. Choose a location where the KEGORATOR™ will be away from heat and will not be exposed to direct sunlight. •... -
Page 8: Parts & Assembly
PARTS & ASSEMBLY Read assembly instructions carefully before installing the KEGORATOR™ . If still unsure whether the KEGORATOR™ has been properly installed after assembly is complete, it is recommended that you contact a qualified installer. Allow the KEGORATOR™ to stand in an upright position for about 8 hours before turning on the power. - Page 9 Parts #1 Keg Coupler #2 Backflow Stopper #3 Rubber Washer (Fits D-Shankey Keg Qty. 1 Valves) Qty. 1 #5 Beer Tower Washer #6 Beer Tap/Hose #7 CO 2 Regulator Qty. 1 Assembly Qty. 1 #9 CO 2 Tank Valve #10 Guard Rail Qty.
-
Page 10: Regulator
REGULATOR The Double Regulator works the CO 2 Tank and measures PSI (pounds per square inch), as well as the volume of the CO 2 gas in the Cylinder. Set Output Pressure Gauge between 8-12 PSI for a nice, frothy head. Output Pressure Gauge... -
Page 11: Installing The Casters
INSTALLING THE CASTERS Follow the steps below to install the Casters. Empty the inside of the cabinet completely and lay the KEGORATOR™ down on it’s side. We recommend that you place a piece of cardboard or cloth underneath the cabinet to prevent dents or scratches. -
Page 12: Co 2 & Tap Tower Installation
CO 2 & TAP TOWER INSTALLATION You must read and understand the steps below for the CO 2 assembly before installation. When you purchase the first keg of beer, you must also have your CO 2 cylinder filled at your local supplier. CO 2 tanks can be refilled at locations such as welding supply shops, party stores, or wherever kegs are purchased. - Page 13 STEP 6 The CO 2 Rubber Directional Washer goes back into the Keg Coupler. STEP 8 Place the Tap Tower on the KEGORATOR™ and feed the hose line through the hole in the top of the KEGORATOR™ . STEP 10 Place Coupler Washer (#3) on top of the Keg Coupler.
- Page 14 Complete CO 2 Tank Installation CO 2 Bottle Double Regulator Beer Tower Tap/ Hose Assembly Connects Beer Tap to Keg Coupler Large Butterfly Nut Secures Hose to Beer Tap Beer Tap Handle Part Connects to CO 2 can be dangerous! CO 2 cylinders contain high-pressured gas, which can be hazardous if handled improperly.
-
Page 15: Tapping The Beer Keg
TAPPING THE BEER KEG (SINGLE VALVE-TYPE KEG) Connect to the Connect to the Connect to Connect to Beer Line Tube Beer Line Tube CO2 Gas CO2 Gas Line Tube Line Tube Black pull handle Black pull handle Keg Coupler Keg Coupler fig. -
Page 16: Helpful Tips
HELPFUL TIPS • It is recommended that you flush the hoses with water prior to first use to remove any dust and debris from shipping. • Only open the CO 2 Tank ¼ turn to begin with and then use the regulator to adjust to desired pour. -
Page 17: Returns & Warranty
RETURNS & WARRANTY SHOULD YOUR UNIT NOT WORK OR IS DAMAGED WHEN YOU FIRST TAKE IT OUT OF THE BOX, PLEASE RETURN IT TO THE PLACE OF PURCHASE IMMEDIATELY. KEGORATOR™ / KRS2000 SERIES Should you have any questions, please contact us via email or at the customer service number listed below between the hours of 8:00 AM and 5:00 PM, Monday through Friday, Central Standard Time.
Need help?
Do you have a question about the Kegorator KRS-2150 and is the answer not in the manual?
Questions and answers