NEC Express 5800/320Lc User Manual page 295

Fail to access to the CD-ROM:
Is the CD-ROM properly set in the CD-ROM drive tray?
→ The tray is provided with a holder to secure the CD-ROM. Make sure that the
CD-ROM is placed properly in the holder.
Is the CD-ROM applicable to the server?
→ The CD-ROM for Macintosh is not available for use.
Is the CD-ROM on the PCI module whose POWER switch is on (primary module)?
→ Although there are two CD-ROM drives, you can only use the one located on the
primary module whose POWER switch is on.
Fail to access the hard disk:
Is the hard disk applicable to the server?
→ Operation of any device that is not authorized by NEC is not guaranteed.
Is the hard disk properly installed?
→ Make sure to lock the hard disk with the lever on its handle. The hard disk is not
connected to the internal connector when it is not completely installed (see Chapter
8). When the hard disk is properly installed, the drive power LED for the hard disk
is lit while the server is powered.
The "An Error occurred while creating partition." error message appears when
installing an OS:
If the following message appears when installing an OS using NEC
EXPRESSBUILDER, you need to perform Low-Level Format again due to reasons
including stoppage.
Referring to "SYSTEM BIOS" in Chapter 4, change the status of [Option ROM
Scan Monitoring] to "Disabled" and then perform Low-Level Format.
After performing Low-Level Format, change the status of [Option ROM Scan
Monitoring] back to "Enabled".
"An Error occurred while creating partition. Press CTRL-C to terminate
installation."
Troubleshooting 7-27