Table of Contents From the Manufacturer • Specifications • SAFETY : Read this first ! • Description of Parts • Ducted vs. Recirculation version • Installation • Wall drilling and bracket fixing Mounting the hood body Connections Chimney assembly Operation •...
From the Manufacturer This appliance and it’s packaging are produced by • processes that minimize waste and respect the environment. Please help us to continue the protection of the environment • by disposing of the packaging in a correct manner. Safety ! Cling film, polystyrene and plastic wrappings must be kept •...
SAFETY : Read this First ! Do not connect the appliance if there are obvious signs of transportation • damage. Read this user manual thoroughly before attempting to use this • appliance. Installation and repair should be attempted only by qualified technical •...
Page 6
This appliance should be connected directly to the fused disconnect (or • circuit breaker) through flexible, armored or nonmetallic sheathed copper cable. Multiple plugs and extension cables must not be used. Overload is • dangerous and may cause a fire. Ensure that the power chord is free from any heat source or sharp •...
Description of Parts A. Chimney Mounting Bracket B. Upper Chimney Cover C. Lower Chimney Cover D. Motor Housing E. Charcoal Filters F. Aluminum Filters...
Ducted vs. Recirculation mode You can choose to install the hood as a ducted or recirculation mode :- Ducted mode (Vented mode) • In the ducted mode, air is drawn into the hood, grease are trapped by aluminum filters. Odors, fumes and condensation are then expelled to the outside. In this mode, only the aluminum filters are installed.
Installation Wall drilling and bracket fixing Wall mounting Draw a vertical line on the at the center of the wall. • From bench top (see A), drawing a horizontal line (see B) above minimum • installation height level. Make a reference point at C, Repeat this step on the other side. •...
Aligning the hood body Before attaching the hood body, adjust the two screws located on the • hood body mounting points. Hook the hood body onto the support screws and tighten the support • screws fully. Adjust screws to level the hood body. •...
Page 11
RECIRCULATION MODE AIR OUTLET Insert the connection extension pieces • Air outlet laterally in air outlet connection. connection Make sure that the outlet of the extension • pieces is horizontally and vertically aligned with the chimney outlets. Connect the air outlet connection to the •...
Chimney assembly Upper chimney Slightly widen the two sides of the upper chimney and hood them behind • the mounting brackets, ensuring that they are well seated. Secure the sides of the brackets using 4 screws (M3 X 12). • Lower chimney Slightly widen the two sides of the chimney and hook them between the •...
Operation Cleaning & Maintenance SURFACES : Wash with warm soapy water and a soft sponge. Never use abrasive detergent, scouring pads, steel wool or solvents on any part of this appliance as this will cause irreparable damage. Dry the kitchen hood using a cloth that does not produce fluff. ALUMINIUM FILTERS : Wash in the dishwasher, it is advisable to stack them vertically to avoid food residue sticking to them.
Troubleshooting Symptoms Possible Cause Action Ensure the plug Motor does not No electrical supply is connected properly. working Reset circuit breaker. Aluminum Clean the filters and Poor airflow filters clogged replace when dry Charcoal filters Replace charcoal clogged filters with new sets Motor running but Butterfly valve Contact technician...
Schematic Diagram From the Manufacturer This appliance and it’s packaging are produced by • processes that minimize waste and respect the environment. Please help us to continue the protection of the environment • by disposing of the packaging in a correct manner. Safety ! Cling film, polystyrene and plastic wrappings must be kept •...
Page 16
The Warranty Card is not provided in the product packaging. You can register the product warranty online at our website https://www.europace.com.sg/ewarranty/ within 7 (seven) days from the date of purchase. You will enjoy an additional 3 months of the product standard warranty when you register online.
Page 17
- Full parts warranty apply to Refrigerators, Air Conditioners & Freezers (Outdoor warranty). Check out the warranty coverage of your appliance at www.europace.com.sg b) The owner waives all or any claims to compensation monetary or otherwise which he/she may be entitled to and shall agree to accept any compensation whatsoever by way of additional repairs or otherwise which we in our absolute discretion may deem t to o er.
Page 18
g) This warranty will not cover chemical cleaning, maintenance service, general service and overhaul, which if con rm is chargeable. h) Defects or fault in the appliance which has been used for commercial purposes or which have been rented/leased or which have been otherwise subject to other than household use.
Page 19
RELATED PRODUCTS & MAIN CONTACT HOTLINE System Split Aircons | Tel: 6858 0801| Email: systemac@strategic.com.sg (Twin City) Portable & Casement Aircons | Tel: 6291 0800 | Email: portableac@strategic.com.sg (Jia Yue) Refrigerators, Washing machines, Cookers & other major appliances | Tel: 6289 0802 | Email: mda@strategic.com.sg (TnG)
Need help?
Do you have a question about the otimmo ECH 8111S and is the answer not in the manual?
Questions and answers
How to remove primo oil cup for model 9148A