SAILS AND RIGGING............................................................................................................................................. 7
STEERING SYSTEM ............................................................................................................................................. 16
ELECTRICAL SYSTEMS ...................................................................................................................................... 17
LP GAS SYSTEM ................................................................................................................................................... 21
OWNER’S MANUAL BENETEAU 40 HULL IDENTIFICATION NUMBER: US-BEY _ _ _ _ _ _ _ _ _ OWNER’S MANUAL BENETEAU PART #: 459920 TABLE OF CONTENTS: INTRODUCTION ..............................3 SPECIFICATIONS OF THE BOAT ......................... 5 III) SAILS AND RIGGING............................. 7 SAFETY ..................................
Page 2
(or any piece of boat equipment) must obtain lessons, gain knowledge and seek experienced advice, before proceeding to use a boat (or any piece of boat equipment). Your Beneteau dealer can advise you on the availability of boating courses, sailing lessons and professional instruction in your area.
Tel (843)-629-5300 Fax (843)-629-5329 We would like to sincerely thank you for choosing a Beneteau and we wish you good sailing. NOTE: Specifications, dimensions, capacities and descriptions are estimations given for general information purposes, and they are not contractual in nature.
Page 4
The users of this boat are advised that: The entire crew should receive appropriate training In some countries, a driving licence or an authorization is needed, or there are specific regulations in force. Always maintain your boat correctly and take into account deterioration resulting from time and significant or inappropriate wear of the boat.
CE CERTIFICATION Your Beneteau has been manufactured in the United States and has been certified by ICNN to be in compliance with the relevant parts of the Recreational Craft Directive 2003/44 EC from the European Parliament. The CE mark means your boat meets or exceeds all current International Organization for Standardization (ISO) standards and directives in effect at the time of manufacture.
Page 6
Maximum recommended number of persons on board by design category: Category Maximum Number of Persons The C.E. Certified equipment includes: The fuel tanks, parts of the steering system, parts of the gas system and the hatches and portholes. For additional information concerning the standard equipment, please refer to the manuals enclosed with the boat. WEIGHT ESTIMATION DESIGN CATEGORIES Boat lightship:...
III) SAILS AND RIGGING SPECIFICATIONS OF THE SAILS: SAILS (as supplied) AREA Roller furling mast Classic mast Roller furling main Classic main 15.00 m 15.00 m 3.95 m Total 73.0 m 77.3 m 3.95 m 13.92 m Mainsail 33.4 m 37.7 m 14.02 m 4.80 m...
SAFETY EMERGENCY EXIT The recommended places for the extinguishers are identified with the symbol On boats fitted with an inboard engine, there is a extinguisher discharge aperture for the engine compartment. For allowing an extinguisher to be used without opening the engine compartment, whose location is identified on the following diagram by the symbol: = Emergency Exit B40 Owner’s Manual...
Page 11
PORTABLE EXTINGUISHERS The boat is delivered without portable extinguishers, the application of the national regulations of the country of registration of your boat are your responsibility. The boat must be equipped, when in service, with portable extinguishers The boat is delivered without portable fire extinguishers. It is your responsibility to comply with the laws and regulations of your country (Number, capacity, type and place of fire extinguishers).
Page 12
Visibility Visibility from the helm station can be obstructed because of high angles of the boat’s trim or because of other factors caused by one or several of the following conditions: Load and distribution of the load Speed Sea state Rain and spray Darkness and fog Light inside the boat...
- Jack lines can be fastened either to the mooring cleats, or to pad eyes on deck. The Beneteau 40 is fitted with a foldaway swimming ladder. The swim ladder should be in its folded/upright position as soon as you are on board.
ENGINE Operating advice Do not install in this boat an engine of superior power or weight than what is recommended, because this could hinder stability. Stop the engine and do not smoke when refuelling. For outboard engines equipped with a separate portable fuel tank, fill the tank away from the boat in a well- ventilated place far from any risks of ignition.
Page 15
FUEL TANK LAYOUT Description FUEL TANK (200 LITRES, 53 gal) FUEL FILLER FUEL GAUGE FUEL FILTER FUEL CUTOFF The indicated capacities cannot be totally used depending on trim, load or the position of filling and possible places of draining. B40 Owner’s Manual Page 15 of 28 June.
VII) STEERING SYSTEM At least once per year check the tension of the cables; in case of doubt, consult your dealer. Boats equipped with a steering wheel are provided with an emergency tiller, make sure that it is accessible at all times. Remove the deck plate, fit the tiller into the socket on the top of the rudder stock for operation.
Never leave the boat unattended when the electrical installation is switched on, except for the automatic bilge pump and systems for fire protection or burglar alarms. Please note; the wires of the 12V system are red for the positives and black for the negatives. Electricity Layout 40 A OPTION BOW THRUSTER 220 Volts / 5 0Hz...
Page 18
ELECTRIC PANEL Description Fuse Voltmeter push button Water level push button Fuel gauge push button Level indicator Navigation lights Anchor light Panel lights Interior lighting Bilge pump Fresh water pump Spare Refrigeration unit Electronics / autopilot Deck light 12V DC Socket 110V AC Battery charger 110V AC Water heater 110V AC Outlets...
Page 19
Location of battery switches, switchboards and electrical appliances Description Shore power inlet 110V Circuit breaker Water heater House battery Windlass circuit breaker Winch circuit breaker (option) 110V Outlet (qty 6) Electric panel Radio Port Speaker Windlass Air-conditioning control panel (option) Air-conditioner unit (option) Stbd speaker Freezer...
Page 20
BATTERY SWITCH OPERATION Never turn the negative battery switch off while engine is running. Never turn all positive switches off while engine is running. Battery 1 is the engine / start battery Battery 2 is the service / house battery Negative battery switch controls ground {DC12V negative} for all batteries.
GAS STOVE Your Beneteau is equipped with a propane stove and oven combination. This unit is located in the galley and is gimbaled for your safety and comfort in a seaway. The stove is supplied by a storage bottle located in a self draining locker in the cockpit.
Page 22
LAYOUT OF THE GAS SYSTEM PROPANE LOCKER REGULATING KIT AND LPG TANK LPG TANK PIG TAIL HOSE PRESSURE GAUGE REGULATOR SOLENOID HOSE TO STOVE B40 Owner’s Manual Page 22 of 28 June. 1, 2007 rev 00...
FRESH WATER AND BLACK WATER TANKS The fresh water system supplies the sink in the galley, the wash basin and shower in all of the heads, and the transom shower. This system is pressurized by an electric pump. There is a filter between the water tank manifold and the pump.
Page 24
Description 80L aft rigid black water holding tank Forward water tank vent Forward water tank filler point 160 L forward water tank Aft water tank vent Aft water tank filler point 200L aft water tank Water pump B40 Owner’s Manual Page 24 of 28 June.
SEACOCKS AND THRU-HULLS B40 Owner’s Manual Page 25 of 28 June. 1, 2007 rev 00...
Page 26
Description Anchor locker drain Deck wash down intake (option) Toilet intake Toilet outlet Round mark = thru hull Macerator outlet (option) without shut off valve Waste tank vent Fresh water tank vent Speed & depth transducers (option) Diamond mark = thru Air conditioning water inlet hull with shut off valve Air conditioning water outlet...
XII) MOORING AND ANCHORING Keep the chain locker hatch cover closed at sea Towing should be done at low speeds A tow should be secured in such a way that it can be released under load The owner should ensure that dock lines, tow ropes, attachment points and chains correspond to conditions of use of the boat.
XIII) HANDLING Contact your BENETEAU dealer for maintenance and repair of your boat. The dealer will advise properly, or will supply you with the spare parts you need or the materials that are suited to your boat. Have your boat hauled & serviced once a year.
Need help?
Do you have a question about the 40 and is the answer not in the manual?
Questions and answers