Advertisement
GRASS CATCHER ASSEMBLY
1. Follow steps below to assemble the grass catcher (if needed).
Make certain bag is turned right side out before assembling
(warning label will be on the outside) (Figure 6).
A. Place bag over frame so that its black plastic side is at the
bottom.
B. Slip plastic channel of grass bag over hooks on the frame.
B
Figure 6
Set-Up
CHECKING THE BATTERY CHARGE LEVEL
Press the charge meter button on the battery (Figure 7). The
number of lights that illuminate will indicate the current charge
level of the battery. If all three lights are dark, charge the battery
before any further use. Refer to Charging a Battery on page 9.
Low
(Charge Battery)
Charge Meter
Button
Figure 7
NOTE: While in use, lithium-ion batteries provide power with
minimal power fade. When the battery is fully discharged, it will
immediately cut power to the mower and require charging.
WARNING
Do not expose the mower to rain or wet conditions.
ASSEMBLY AND SET-UP
A
Full
Charge
Medium Charge
GRASS CATCHER
1. Lift mower rear discharge door. (Figure 8).
2. Place grass catcher into the slots in the handle brackets.
Release discharge door so that it rests on the grass catcher.
To remove grass catcher, lift mower rear discharge door. Lift
grass catcher up and off the slots in the handle brackets. Release
mower rear discharge door to allow it to close.
SIDE DISCHARGE CHUTE/MULCH PLUG
Your mower was shipped as a mulcher. To convert to side
discharge, make sure grass catcher is not installed and rear
discharge door is closed.
1. On the right side of the mower, lift the mulch plug (Figure 9).
Mulch Plug
2. Slide two hooks of side discharge chute under hinge pin on
mulch plug assembly. Lower the mulch plug.
IMPORTANT: Do not remove mulch plug at any time.
To remove side discharge chute, lift the mulch plug. Lift the side
discharge chute up to release the slide hooks from under the
mulch plug hinge pin. Release mulch plug to allow it to close.
12
2
1
2
Figure 8
1
2
Figure 9
Advertisement
