Stick Calibration; Power Off - FlySky FS-ST8 User Manual

4.4 Stick Calibration

The calibration is required in case of data offset of the transmitter due to physical wear in long-term operations. At
this time, we need to calibrate the output data and neutral angle of the stick, throttle trigger, and potentiometers.
The transmitter has been calibrated at the factory. If you need to recalibrate it, please follow the steps below to
perform the settings:
1. Power on the transmitter, enter the TX SET menu, and select the
CALIBRATION function. Follow the prompts to press the START for
calibration.
2. Swing the sticks to the maximum and minimum travel range in each
direction respectively and then release them.
3. Tap CALIBRATION to exit the calibration interface. The calibration is finished.
Note: If the pop-up window indicates that the calibration has failed, it means that the control
to be calibrated has not reached the maximum and minimum travel range, the recalibration
is required.

4.5 Power Off

Follow the steps below to turn off the system:
1. Disconnect the receiver power.
2. Press and hold to turn off the transmitter.
• Make sure to disconnect the receiver power before turning off the transmitter. Failure
Danger
to do so may lead to damage or serious injury.
7