Table of Contents
Advertisement
8 | en
Notes:
Depending on how the device is
f
configured, you will have access
to either the HDMI input or the
AV1 and AV2 inputs (for further
information on this, see also the
"Configuration" section in the
"Important information"
chapter).
f
If the AV1, AV2 or HDMI input is
selected without there being an
input signal present, "No signal"
is displayed.
For information about playback
f
from a connected USB storage
device, see the "USB mode"
chapter.
It is not possible to play
f
HDCP-encrypted content (e.g.
from a Blu-ray Disc) via the HDMI
port.
When playing media via the
f
HDMI input that originate from
regions with frame rates other
than 50 Hz, smooth playback
may be impaired at the outputs
for reasons related to the
system.
TV mode
When TV mode starts, the current channel is
played, and the channel information is shown
for around 5 seconds.
Displaying channel information
f Press the i button (11) .
7 620 320 035 | 11.2021
Selecting a media source | TV mode
The channel information is shown for around 5
seconds.
Note:
You can set the length of time you
want the channel information to be
shown (see the section entitled
"Setting the display duration for the
on-screen menu" in the "System
settings" chapter).
Switch to the next/previous chan-
nel
f Press the P+ or P– button (15) .
The next or previous channel is played, and the
channel information is shown for a short time.
Selecting channels in the channel
list or favourites list ("myList")
To display the channel list or favourites list
("myList"),
f press the i button (11) (if necessary) to
show the channel information.
f Press the OK button (6) .
Note:
The channel list is only displayed
when there are no channels stored in
the favourites list ("myList").
Otherwise, the favourites list is
displayed.
To select a channel,
f use the P+ / P– buttons (15) to select the
desired channel.
To play the channel,
f press the OK button (6) .
Robert Bosch GmbH
Advertisement
Table of Contents
