Advertisement
5.3.
CLEANING THE OIL DISCHARGE HOLE (fig.17)
5.3.1.
Small dust or particles may be built up in the oil dis-charge hole during operation. These dust or particles may impair the oil to flow
and cause an insufficient lubrication on the whole saw chain. When a poor chain oil delivery occurs at the top of guide bar, clean the oil
discharge hole as follows.
5.3.2.
Remove the sprocket cover and saw chain from the tool. See section 4.3, 4.4 for removal.
5.3.3.
Remove the small dust or particles using a slotted screwdriver with a slender shaft or the like.
5.3.4.
Insert the battery cartridge into the tool. Pull the switch trigger to flow built-up dust or particles off the oil discharge hole by discharging
chain oil.
5.3.5.
Remove the battery cartridge from the tool. Reinstall the sprocket cover and saw chain on the tool.
5.4.
REPLACING THE SPROCKET (fig.18)
NOTE:
A worn sprocket will damage a new saw chain. Replace the sprocket if damaged.
5.4.1.
Remove the sprocket cover, saw chain and guide bar. See section 4.3, 4.4 for removal.
5.4.2.
Refer to fig.X for indication of areas of most wear on sprocket.
5.5.
Ensure that the circlip is replaced to securely hold the new sprocket safely in place (fig.19).
fig. 18
6. STORAGE
6.1.
Clean the tool before storing. Remove any chips and sawdust from the tool after removing the sprocket cover.
6.2.
After cleaning the tool, run it under no load to lubricate the saw chain and guide bar.
6.3.
Cover the guide bar with the guide bar cover.
6.4.
Empty the oil tank.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
01284 703534
sales@sealey.co.uk
Original Language Version
fig. 19
www.sealey.co.uk
CP20VCHS
Issue 1
24/09/21
Advertisement
