Saunacore Steamcore Pro Series Installation Manual & Owner's Manual page 18

Installation instruction of controller
Important:
Step one
Determine the installation location of the controller.
The controller is designed to be installed in the steam
room :
1. 4-5 feet from the ground.
2. Away from the steam nozzle and do not expose
under the direct path of steam.
3. Installation on perpendicular wall.
4. The position of installation should facilitate easy
operation and convenient wiring.
The controller wire is 1.0 feet long with a controller
lengthened wire of 20 feet long at the most. In the
installation of controller, it should be in a position not
more than 21 feet from the steam engine. If longer
wire is needed, contact professional service personnel.
Important:
water pipe or in a position where water comes into contact.
Step two
Drill a round hole of
position, no larger or smaller.
Step three
Pull the controller
connect it to the lengthened wire and then to the steam
,
generator and connect with the corresponding wire in
.
generator When the computer wire is plugged in, aim
the direction and insert horizontally, instead of shaking
left and right in case the computer needles could be
the same
damaged. Do
Important:
controller wire in case of causing damage to it.
Step four
Start the power supply of steam engine, check and
adjust connection,
make sure all functions
Important:
sure the steam generator is shut off otherwise the
be
controller may
Before installing the controller, make sure the steam generator is shut off
otherwise the controller may be damaged.
Do not install the controller under the
35mm in diameter in a chosen
wire through the round hole,
when unplugging.
Do not pull tight, or clip tight the
check each item on the page to
work well.
before repairing the controller, make
damaged.
the
at
Steam Generator
18
User Manual
Control Panel SS I
SS II
Control Panel
(1ft)
Extended wire
(1ft)
Aor
(20ft)