Nectar move NECFL03 Owner's Manual page 11

Applying anti-skid pads for platform use
Your adjustable bed is also created for platform or slatpack bed systems. Before installing on a platform or slat
pack bed, apply anti-skid pads under the adjustable bed to keep it in place.
1
Turn your adjustable bed on its side and then locate the
areas near the center brackets and corner brackets of
the frame.
NOTE:
For safety reasons, lifting of the adjustable bed
must always be performed by two (2) people.
2
Take the anti-skid pads and remove them from the
adhesive backer.
3
Apply the anti-skid pads on each of the identified areas
near the center and corner brackets as shown.
IMPORTANT!
• Make sure to align the anti-skid pads so that they
will rest on one of the slats under the power base. If
your bed system is a solid deck surface, there is no
need to align the pads to a slat.
• For the areas near the center brackets, you may
apply the anti-skid pads to either side of the center
bracket. Make sure to align them with the slats.
• A total of 6 anti-skid pads must be applied to the
power base to secure the frame in place and keep it
from slipping.
4
After applying all the anti-skid pads under the power
base, carefully place the power base onto the platform
or slats.
5
Continue setting up the electronics and other parts of
your power base on page 9.
Installation Guide
The anti-skid pads are packed
inside the parts box.
11