Control Panel; Panel Overview; Power Switch (On/Off); Status Lamp - Bosch Rego 1000 User Manual

Control panel

2 Control panel
Settings for the control of the heat pump are made with the control unit's
control panel, which also provides information about current status.
2.1

Panel overview

1
2
mode
info
3
4
Fig. 1 Control panel
[1] On/Off button
[2]

Mode button

[3]

Info button

[4] Menu dial
[5]

Status lamp

[6]

Return button

[7] Menu button
[8]

Menu display

2.2

Power switch (ON/OFF)

Use the On/Off button to turn the heat pump on and off.
2.3 Status lamp
The lamp lights green.
The lamp flashes red.
The lamp lights red.
The lamp flashes slowly green,
menu window not lit.
The lamp and menu display not
lit.
Table 2 Lamp functions
1) Stand-by means that the heat pump is running but no heating or hot water
demand exists.
2.4 Menu display
Use the menu display in order to:
• See information from the heat pump.
• See available menus.
• Change set values.
2.5

Menu button and menu dial

Use to get from Initial menu to the menus. Use the menu dial in
order to:
• Navigate the menus and get to the setting displays.
– Turn the dial to see more menus on the same level or change a set
value.
– Press the dial to change to a lower menu level or save a change.
2.6 Return button
Use to:
• Go back to the previous menu level.
4
menu
ok
6 7 20 643 420-01.1I
The heat pump is running.
There is an alarm which has not been
acknowledged.
The alarm has been acknowledged
but the alarm cause remains.
The heat pump is in stand-by mode
No voltage to the control unit.
• Leave a setting display without changing the set value.
2.7 Mode button
Use to change type of operation.
• Change type of operation.
The controller language can be changed with the
button.
▶ Press the
5 s, then select the required language.
8
2.8 Info button
7
Use to see information from the control unit about operating
6
mode, temperature, program version, etc.
5
3

Menu navigation

3.1

Initial menu

Initial menu shows different temperatures, time, as well as current
operating symbols. The window displays information alternately Room
temperature (if room sensors exist) and Flow temperature for each
circuit installed.
7
Fig. 2 Initial menu
[1] Outdoor temperature
[2] Current operating symbols
[3] The circuit room temperature
[4] Current time
[5] Hot water temperature
1)
.
[6] Circuit flow temperature
[7] Circuit number
Fig. 3 Initial menu, circuit 2 is displayed
3.2

Finding desired function and changing value

Menu overview ( Page 7) shows the main functions that are reached
with and the dial.
▶ Press .
Fig. 4
button in the initial menu for at least
6 720 805 492-01.1I
6 720 805 492-02.1I
6 720 807 583-01.1I
Rego 1000 – 6 721 831 662 (2021/03) en