SECTION 2 DISASSEMBLY Note : Follow the disassembly procedure in the numerical order given. 2-1. REAR CABINET 3 Three screws (P2.6 × 16) 4 Two screws 2 Stand (P2.6 × 16) Claw 5 Cabinet (rear) (The cabinet is locked by the claws) 1 Lid, battery case 2-2.
2-3. DIAL POINTER SETTING 3 Screw (1.7 × 3) Flat (+) special 5 Scale, dial 2 Mach the hole with setting the variable capacitor gear gap in the arrow A direction. 4 Belt (Tun) 1 Turn the variable capacitor fully counterclockwise. 6 Pointer Center of scratched line...
SECTION 3 ELECTRICAL ADJUSTMENTS FM section • This adjustment should be executed after MW band adjustment 0 dB=1µV Setting is completed because the LW and SW bands use the BAR ANT BAND switch : FM and CV1 in common with the MW band. Therefore, if MW band is adjusted, the LW and SW bands must FM RF signal also be readjusted.
Page 7
[VCO Adjustment] SW FREQUENCY CENTER ADJUSTMENT Procedure : Adjust for a maximum reading on Level meter. 4.85MHz (3.88MHz) FM RF signal generator 6MHz 7.2MHz 9.62MHz 11.8MHz 13.65MHz Center frequency :98 MHz Modulation : no modulation 15.35MHz Output level : 0.1 V (100dB) telescopic antenna input 17.65MHz 21.6MHz...
ICF-SW11 4-2. PRINTED WIRING BOARD MAIN BOARD TUNE ANTENNA ANT1 TELESCOPIC ANTENNA VOLUME EXCEPT JE MODEL EXCEPT JE MODEL CV-1,CT-1 CT1-1 TUNING CV1-1 JE MODEL CV1-2 CT1-4 SP901 (SPEAKER) SI BAND POWER DC IN 3V (15) DRY BATTERY SIZE "AA"...
ICF-SW11 4-3. SCHEMATIC DIAGRAM • Refer to page 8 for IC Block Diagrams. L5, CT3 L4, CT1-2 L6, CT1-3 L2, CT2 L1, CT1-1 MW FREQUENCY COVERAGE FM TRACKING LW FREQUENCY COVERAGE LW TRACKING MW TRACKING L7,CT1-4 FM FREQUENCY COVERAGE L17-L25...
Ver 1.1 2001. 10 SECTION 5 EXPLODED VIEWS NOTE: • -XX, -X mean standardized parts, so they may • Hardware (# mark) list and accessories and have some differences from the original one. packing materials are given in the last of this •...
SECTION 6 MAIN ELECTRICAL PARTS LIST NOTE: • Due to standardization, replacements in the • CAPACITORS: • SEMICONDUCTORS parts list may be different from the parts uF: µF In each case, u: µ, for example: specified in the diagrams or the components •...
Page 16
ICF-SW11 REVISION HISTORY Clicking the version allows you to jump to the revised page. Also, clicking the version at the upper right on the revised page allows you to jump to the next revised page. Ver. Date Description of Revision Correction of exploded views 2001.10...
Need help?
Do you have a question about the ICF-SW11 and is the answer not in the manual?
Questions and answers