Replacing The V-Belt On The Front Side Of The Unit - Lissmac SBM-M 1000 D2 Operating Manual

Abb. 23:
Deslagging machine SBM-M 1000/1500 D2

7.5. Replacing the V-belt on the front side of the unit

NOTE
Always replace the V-belts in pairs.
If V-belts are replaced individually, secure drive is no longer possible.
Front side v-belts
 Lightly loosen the fastening nuts of the tensioning plate.
 Loosen counter nuts of the tension device and turn back.
 The v-belt can be relaxed using the tensioning device.
 Remove the V-belt.
 Put new V-belt into place.
 Re-tension and secure using the tensioning device.
 Tighten the fastening nuts on the tensioning plate again.
 Check the belt tension.
Service
47