Table of Contents
Advertisement
Operating Modes
Operating Modes
Data Generator Mode
Pulse Generator Mode
1-2
The
data timing generator is controlled by the DTG5000 software
DTG5000 Series
running on the Windows 2000 operating system and operates in Data Generator
(DG) mode or Pulse Generator (PG) mode.
The
operates as a data generator that outputs pattern data
DTG5000 Series
repeatedly. If you have defined a sequence, the
The
DTG5000 Series either
or imports data created with an external simulation software tool or other similar
software, and then outputs the data. The output timing is determined by the
sampling clock rate.
Pattern data can be controlled in the following ways:
Timing Control Delay, Width/Duty, Cross Point, Slew Rate
Level Control: Amplitude, offset
The
operates as a pulse generator. A typical clock pattern is
DTG5000 Series
generated as the data pattern being output. The output timing is determined by the
output frequency.
Pattern data can be controlled in the following ways:
Timing Control Pulse Width, Delay, Duty, Tr/Tf
Level Control: Amplitude, offset
DTG5078 & DTG5274 & DTG5334 Data Timing Generator User Manual 2
DTG5000 Series
uses data created with the DTG's built-in pattern editor
runs it repeatedly.
Advertisement
Table of Contents
