Setup Menu Options - MSB Technology Select DAC User Manual

Saving Menu and Startup Settings
When changing settings in the menu, use the enter button in the
center of your volume wheel on the remote or the circle on the DAC
faceplate to confirm settings in the DAC menu. After you have made
your changes in the DAC menu, use the menu button to exit the DAC
menu completely to save the changes you have made in the DAC
menu.
The DAC will not save any of your settings until you exit the menu.
The "Action Buttons" on your remote change certain settings on
your DAC without navigating the DAC menu (Phase Invert and Video
Mode). However, these settings reset every time the DAC is reset or
powered off. If you would like these settings to persist through resets
or power offs, you simply have to choose the action button setting
that you wish to be default and then enter and exit the DAC menu by
double clicking the Menu button on your remote or DAC faceplate.
If at any point the DAC seems to be improperly setup or you want to
start fresh with your settings and functions, there is a "Reset" option
near the end of the DAC menu. Simply select this and confirm "YES"
before closing the DAC menu and restarting the unit.

Setup Menu Options

Display
brightness
Display On (Default)
DSD mode Optimized
Startup
volume
This can be adjusted from 1 - 10
• The display is on continuously.
Auto off
• The display is off but will turn on momentarily when
the volume or input changes.
• The optimized mode is the DSD decimation done
using a special method developed by MSB.
Native DSD (Default)
• The Native DSD signal is sent unprocessed direct to
the Hybrid DAC modules.
0 - 100
• This is the default volume the DAC will power up at.
Volume Disabled
• If you choose to use the DAC with a external preamp,
you can set turn the volume control off.