Table of Contents
Advertisement
6. Fan Assembly (flushmount).
(cont.)
To prepare the fan for wiring, hang fan
onto hanging bracket by sliding the
canopy over the hanging bracket tab. (Use
one of the non-slotted holes on the rim of
the canopy to do so.)
[Refer to diagram 3.]
7. Wiring.
WARNING: Turn off circuit breakers to
current fixture from breaker panel and be
sure switch is turned to the OFF position.
CAUTION: Be sure outlet box is properly
grounded and that a ground (GREEN or Bare)
wire is present.
Make sure all electrical connections comply
with Local Codes or Ordinances and the
National Electrical Code. If you are unfamiliar
with electrical wiring or if the house/building
wires are different colors than those referred
to in the instructions below, please use a
qualified electrician.
When downrod is secured in place on the
hanging bracket, electrical wiring can be
made as follows:
Connect BLACK and BLUE wires from fan
to BLACK wire from ceiling with wire
connector provided.
Connect WHITE wire from fan to WHITE
wire from ceiling with wire connector
provided. Connect all GROUND (GREEN)
wires together from fan to BARE/GREEN
wire from ceiling with wire connector
provided.
If you intend to control the fan light with a
separate light switch, connect BLUE wire
from fan to the BLACK (or RED) supply
from the independent switch.
*Wrap each wire connector separately with
electrical tape as an extra safety measure.
This fan is remote control adaptable (remote
control sold separately).
canopy
diagram 3
white supply wire
black supply wire
from
ceiling
black
white
wire
connectors
white
black
blue
from fan
page 7
hanging bracket tab
motor housing
ground
(green or bare)
wire
connector
ground
(green
or bare)
*
Advertisement
Table of Contents
