Safety Instructions
•
Ensure the power supply is switched off before fitting, servicing or changing the doorbell.
•
This fitting must be installed in
accordance with the current edition of
the IEE Wiring Regulations.
If in doubt, contact a qualified
electrician.
Remove Screw
Specification
Supply Voltage Dimensions (mm)
S06
INS 0017 V1.1 03/20 NPD 0547
AC
Bell
230 V
Push
AC
Power
240V~
128(H), 128 (W), 44 (D)
Instruction leaflet
To be read in full before installation and kept for future reference
Installation Instructions
•
Switch off the electricity at the fuse box before proceeding with the installation
•
Remove the front cover of the doorbell by removing the screw underneath
•
Mount the back section of the doorbell to the wall using fixing screws
•
Connect a 240V supply to the live and neutral terminals
•
Connect appropriate bell wire (not supplied) to the unbiased terminals inside the doorbell (see
diagram), and route to the position of the bell push
•
Remove the front cover of the bell push
•
Connect the other end of the bell wire to the terminals of the bell push
•
Bell push seal must be fitted to the rear of the bell push, with the cable routed through "+"
shaped slot. Failure to fit this seal will affect the guarantee.
•
Secure the bell push in its position
•
Replace the front cover of the bell push
•
Replace the front cover of the doorbell, and secure in place with the screw
•
Switch on the electricity at the fuse box by replacing the relevant fuse or switching on the
circuit breaker after completing the installation.
Please note
•
For longer cable runs, cable with a larger cross sectional area is advised, eg.13 strand speaker
flex
Door Bell Type
Kit Contents
Door Bell
Mechanical Sounder
Door Bell, Bell Push and Bell Push Seal
Deta Electrical Company Ltd
UK: Panattoni Park Luton Road Chalton Beds. LU4 9TT
EU: Unit 16 Ashbourne Ind. Est. Ashbourne Co. Meath A84 W972 Ireland
deta.co.uk | Technical Helpline: +44(0)1582 544 548
C3504