Philips EasyKey 6000 Series User Manual page 8

Change the rear handle direction
Screw
Screw
Unscrew two screws
1
and remove the
direction reversing
stand.
Attention
1. Please choose the proper installation kit to suit your door thickness.The default installation
kit is applicable for a door thickness of 60-90mm. If your door thickness does not within this
range, please feel free to contact us.
2. The bar shall be cut to an optimal length as per the thickness of door.
Step 3 | Change the direction of latch bolt
Change the direction of the latch bolt to suit your door swing direction. If the slant
of the latch bolt faces the outside door, then it is the inward opening door. If the
slant of the latch bolt faces the inside door, then it is the outward opening door.
Latch bolt
6
Direction
reversing stand
Rotate the handle
2
to 180 degrees for
optimal placement.
Inverting tailpiece
Screw
1. Push the inverting tailpiece to the top.
2. Press the latch bolt down to the mortise surface,
then rotate it 180 degrees and pull it out.
3. Push the tailpiece to the bottom.
4. Change the direction of the directional screw based
on the door swing direction.
(The directional screw must be installed on the interior
door that is equipped with rear escutcheon)
Put the direction
3
reversing stand back and
tighten the screws.