Sharp IB-HD16 Manual page 18

英語翻訳
How to use
1
Please confirm that the voltage switch is at a correct position.
In case of using with the voltage switch at "100/120V" and power
voltage of 200～240V, the safety device works and the operation
stops.
When the operation stops, set the main switch
to "OFF", set the voltage switch to "200/240V",
wait for a few minutes, and then operate again.
In case of using with the voltage switch at "200/240V" and power voltage of
100～120V, enough hot wind is not supplied and drying/dressing takes time.
Set the main switch to "OFF", set the voltage switch to "100/120V", and then
operate.
2
Inset the plug to a socket after checking a shape of socket.
3
Use after setting the main switch to your favored position.
4
After using, turn the main switch
to "OFF" and pull off the power plug.
Maintenance
● [Air inlet / outlet]
Please remove dust etc. on the
air inlet and outlet with commercially
available brush or tissue at least one
time per month.
● [Body / accessories]
Please wipe the surfaces of
body and accessories with a
soft cloth once they get dirty.
● [Plasmacluster unit]
Please pull off the plug, insert the unit cleaning brush to the air
outlet and cleaning hole, move it forward and backward for
around three times, and remove dirt on the electrode sections
(two points) at least one time per two months.
(Please refer to the drawing on the right)
18
(
English
Unit cleaning brush
)
Main Switch Nozzle for setting
Quick drying TURBO
Setting
SET
Styling COLD
Stop using
OFF
Electrode sections
Cleaning hole Plasmacluster unit
TURBO
SET
COLD
OFF
remove
attach
attach