Setup; Checking The Work Light And Package Contents; Charging The Work Light; Operation - Workzone 937 User Manual

Setup

Setup

Checking the work light and package contents

PLEASE NOTE!
Risk of damage!
If you open the packaging carelessly with a sharp knife or other
sharp objects, the work light could easily be damaged.
− Be very careful when opening the packaging.
1. Remove the work light from the packaging.
2. Check that all package contents are present (see Fig. A).
3. Check if there is any damage to the work light or the individual components.
If that is the case, do not use the work light. Please contact the manufacturer
via the service address indicated on the warranty card.

Charging the work light

Before using the work light for the first time, you must fully charge its battery.
Charging the battery takes approx. 6 hours.
PLEASE NOTE!
Risk of damage!
Incorrect handling of the work light may potentially damage it.
− Always switch off the work light while it is being charged.
1. Make sure that the work light is switched off.
2. Fully unwind the USB charging cable
3. Plug the micro-USB connector into the micro-USB socket
To do so, lift up the protective cover
4. Plug the cable into a USB port on a computer, laptop, etc. The battery charge level
flashes green while the battery is being charged (see Fig. B).
indicator 3
5. As soon as the battery is fully charged, all three battery charge level indicator
lights will show blue. Disconnect the work light from the power supply.
12
2
.
5 on the work light.
7 (see Figs. A and B).

Operation

The work light cannot be used while it is being charged.
The work light offers two brightness levels (100 % and 50 %).
1. To check the charge level of the battery, press the battery charge level indicator
button 4 (see Fig. B). If the battery is fully charged, all three battery charge
level indicator lights 3 will show blue. The lower the charging level, the lower
the number of active indicator lights. If the battery is fully charged, the work light
can be used for approx. 2 hours (100 %) / 4 hours (50 %).
2. Use the carry handle 1 to carry the work light to where you wish to use it.
3. To switch on the work light, press the On/Off switch
The LED will then switch on at 100 % brightness.
4. To reduce the brightness, very lightly press the On/Off switch.
The LED will then switch to 50 % brightness.
5. To set up the work light, tilt the carry handle so that the light shines on
the work area at the desired angle.
6. To switch off the work light, press the On/Off switch.

Using the battery as a power bank

− Connect the device you wish to charge to the work light using a USB charging
cable by plugging the USB connector into the USB socket
Operation
8 (see Fig. B).
(see Fig. B).
6
13