Bosch BI.7101 Series User Manual And Installation Instructions page 18

en Installation instructions
ATTENTION!
Covering the ventilation slots and air intake openings
causes the appliance to overheat.
Do not cover ventilation slots and air intake open-
▶
ings.
If the appliance is installed behind a decorative panel,
this may cause it to overheat.
Do not install the appliance behind a decorative
▶
panel.
When the door is opened, the appliance may tip over.
Above the appliance, provide a fixed intermediate
▶
floor in the fitted unit.
When combined with an oven, provide a fixed inter-
▶
mediate floor above the oven.
The built-in unit must not have a rear panel behind the
appliance.
If no intermediate floor is possible above the appliance
or above the oven, install tilt protection for the appli-
ance → Page 18. Suitable tilt protection can be ob-
tained from customer service, on our website or in the
online shop.
Installing the appliance
WARNING ‒ Risk of injury!
When the door is opened, the appliance may tip over.
In the case of installation without an intermediate
▶
floor, weigh down the appliance with a suitable
weight before opening.
1. Insert the power cable fully into the appliance.
Push the appliance all the way into the fitted unit.
2.
Do not pinch the power cable.
‒
Centre the appliance.
3.
Remove the adhesive strip from the appliance front.
4.
Open the appliance.
5.
Screw the appliance to the fitted unit.
6.
Insert the power cable into a protective contact
7.
socket.
18
The power cable must not touch the rear and base
of the appliance after installation.
Fitting tilt protection
Suitable tilt protection (order number: 12039458) can
be obtained from customer service, on our website or
in the online shop.
Measure and mark a clearance of 520 mm from the
1.
front edge of the unit.
Screw the two brackets into the elongated hole on
2.
the mark.
Place the appliance on a flat surface.
3.
Unscrew the two lower screws on the back of the
4.
appliance.