Samsung BF1N4T123 User Manual page 52

installation
Safety instructions for installation
This oven may be installed only by an approved electrician. The installer is responsible for
connecting the appliance to the main supply, while observing the relevant safety regulations.
• Ensure protection from live parts when installing the oven.
power connection
If the appliance is not connected to the mains with a plug, a multi-pole
isolator switch (with at least 3 mm contact spacing) must be provided in
order to satisfy safety regulations. The power cable (H05 RR-F or H05 VV-F,
min. 1.5~2.5 mm²) must be of sufficient length to be connected to the oven,
even if the oven stands on the floor in front of its built-in cabinet. Open the
rear connection cover of the oven with a screwdriver and loosen the screws
of the cable clamp before you connect the power lines to the relevant
connection terminals. The oven is earthed via the (
and green cable (earth connection) must be connected first and be longer than the others. If the oven is
connected to the mains with a plug, this plug must remain accessible after the oven is installed. Samsung
will take no responsibility for accidents that originate from a missing or faulty earth connection.
WARNING: Do not allow the connecting cable to become trapped during installation, and
prevent it coming into contact with hot parts of the oven.
installation in the cabinet
With built-in furniture, plastic surfaces and adhesive for the oven should be resistant to 90 °C inside of
the furniture and to 75 °C for adjacent furniture. Samsung will take no responsibility for damage of plastic
surfaces or adhesive from the heat.
There should be a ventilation gap in the base of the kitchen cabinet where the oven is to be placed.
For ventilation, a gap of about 50 mm should be left between the lower shelf and the supporting wall.
If the oven is to be installed below a hob, the hob's installation instructions should be followed.
Min.550
370
Max.50
595
572 550
595
21
Built-in
Push the appliance completely into the cabinet and fix the oven firmly on both sides using 2 screws.
Make sure that a gap of at least 5 mm should be left between the appliance and the adjacent cabinet.
After installation, remove the vinyl protective film, tape, paper and accessories from the door and inside
of oven. Before uninstalling the oven from the furniture, disconnect the oven from the power supply and
release the 2 screws on the both sides of the oven.
WARNING: The built-in furniture must have a minimum ventilation gap for Air-flow as shown
in picture. Do not cover this hole with strips of wood, for this is used to provide ventilation.
The front exterior of the oven such as handle is different model by model. But the size of the
oven in the picture is same.
BF1N4T123_XEO_DG68-00069P-02_EN.indd 4
Min.560
Min.50
560
Min.590 ~
Max.600
545
Min.460 x Min.50
English - 4
BROWN
or BLACK
)-terminal. The yellow
Min.550
175
370
560
115
595
572 550
Max. 476
595
Max.
545
464
21
BLUE or YELLOW
WHITE and GREEN
Min.560
Min.600
Min.460 x Min.50
Built-under
Built-in + Built-under
2015-02-27 1:27:02