Rebooting The Firewall - H3C SecPath F10X0 Installation Manual

Task
Display key parameters of the
transceiver module in a specific
interface.
Troubleshooting transceiver modules
The system outputs alarm information for you to locate and troubleshoot faults of transceiver
modules.
To display the alarming information or fault detection parameters of a transceiver module:
Task
Display the current alarm
information of the transceiver
module in a specific interface.

Rebooting the firewall

CAUTION:
• If the main system software image file does not exist, do not use the
the firewall. Specify the main system software image file first, and then reboot the firewall.
• The precision of the rebooting timer is 1 minute. 1 minute before the rebooting time, the firewall
prompts "REBOOT IN ONE MINUTE" and reboots in one minute.
• If you are performing file operations when the firewall is to be rebooted, the system does not
execute the
To reboot a firewall, use one of the following methods:
•
Use the
•
Enable the scheduled reboot function at the CLI. You can set a time at which the firewall can
automatically reboot, or set a delay so that the firewall can automatically reboot within the delay.
•
Power on the firewall after powering it off, which is also called hard reboot or cold start. H3C
does not recommend that you use this method because it might cause data loss and hardware
damages.
To reboot the firewall immediately:
Task
Reboot the firewall immediately.
To enable the scheduled reboot function:
Task
Enable the scheduled
reboot function.
Command
display transceiver
interface
[
interface-number
Command
display transceiver
alarm interface
[
interface-number
reboot command for security.
command to reboot the firewall immediately.
reboot
Command
reboot
Command
•
Enable the scheduled reboot function
and specify a specific reboot time and
date:
scheduler reboot at
•
Enable the scheduled reboot function
interface-type
interface-type
5-39
Remarks
Available for all transceiver
modules.
]
Remarks
Available for all transceiver
modules.
]
reboot
Remarks
Available in user view.
Remarks
Use either approach.
The scheduled reboot function is
disabled by default.
Available in user view.
command to reboot