Advertisement
B. Make sure the phase hole of the Main Cam Gear on the bottom side
of Mechanism Unit is in EJECT position.
C. Install the Mechanism Chassis straight onto the Main C.B.A. so that
the Sensor LED clears the hole in the Mechanism Chassis and that 3
Connectors (P3501, P4001, P6201) are aligned and seated securely.
5.2. MECHANISM SECTION
Refer to the Service Manual for R4-Mechanism Chassis for PV-Model (Order No. MKE0401000C1).
5.3. DVD SECTION
Note:
Some parts have been changed on running change basis. Therefore, disassembly and assembly
methods are slightly different between early products and later products. Please refer to "11 PARTS
CHANGE INFORMATION".
5.3.1. Disassembly Flowchart
Perform disassembly procedures in the order described in the "Disassembly Flowchart" Shown
below. When reassembling, use the reverse procedure.
Fig. C5
22
Advertisement
