Table of Contents
Advertisement
Setup
Loose Parts: Use the list below to verify that all parts have been shipped.
Step
Description
1
Pad Assembly
2
Oil And Air Filter
3
Rotate Cylinders
4
Rotate Handle
5
Tire Pressure
6
Probes
7
Charge The Battery
Additional Parts:
•
Ignition Key
•
Battery Cutoff Key
•
Operator's Manual
•
Compressor Manual
Note: The rear of the machine is located at the Operators handle, and is the normal operator position. Left and
right are in relation to the direction of travel as you walk with machine in front of you.
Note: To raise the center beam after uncrating the machine, start the engine. The beam should raise after the
machine gets to pressure. Refer to Starting the Engine in the operations section of this manual.
Note: Check all hoses, fasteners and probes for tightness prior to operating the machine.
6
Qty.
3
2 - quarts oil, 2 air filter
2
1
3
3
Use
Screw in to install under probes- wrench
provided in toolbox to tighten
Compressor oil and air filter
The outside air cylinders are rotated for
shipping, rotate so as shown
Handle is folded down for shipping. Loosen
bolts and move to desired location.
Check tire pressure. Set at rating on tire.
Install the length of probes desired.
Probes are located in the toolbox.
FOLEYCO.COM
Advertisement
Table of Contents
