Silvercrest SDBC 3.5 A1. Instruction Manual page 61

352%/(0
Water drops from the Water drops from the
iron soleplate iron soleplate
13
The iron soleplate
is dirty or it stains the
clothes.
Steam comes out of
the iron permanently.
Dirty water comes out
of the iron.
Steam comes out of
the saftey cap the saftey cap
5($621
The temperature of the
. . soleplate is too low or
the steam setting too
high.
Condensed water
remained in the iron
cord cord
21
are using the ironing
FHQWUH IRU WKH ÀUVW WLPH
or after a long break.
The steam button The steam button
has been pressed for a
long time or permanent
steam has been used for
a long time.
The temperature setting
13
is too high.
The lock slider on the
steam button steam button
is activated.
There is too much lime-
scale in the boiler or the
iron.
Some kind of addictive
has been mixed to the
water.
The safety cap The safety cap
. . ÀUPO\ FORVHG
1
The o-ring is faulty.
, because you , because you
12
12
is not is not
1
58
62/87,21
Check steam and tem-
perature settings with
table in chapter 9.
Press the steam supply Press the steam supply
button button till you get till you get
12
steam.
Press the steam button Press the steam button
only for a short time
when needed.
Turn the temperature Turn the temperature
adjustment knob adjustment knob
to a lower setting.
Release the lock slider
on the steam button on the steam button
Decalcify the boiler and
the iron.
Contact the costumer
service.
Close the safety cap Close the safety cap
correctly.
Contact the costumer
service.
12
11
. .
12
1