Compressor I/O Board Mounting Details; Compressor I/O Board Mounting Instructions - Danfoss Turbocor TTS Series Applications And Installation Manual

4.3 Compressor I/O Board Mounting Details

The Compressor I/O Board ( Figure 4-4 Compressor I/O Board) must be installed in a Underwriters Laboratories (UL)
approved electrical enclosure equipped with DIN EN 50022, 50035, or 50045 mounting rails. The board should be
mounted in a dry area, free from vibration and electrical noise.
The UL listed enclosure should protect against moisture and other corrosive elements.
Figure 4-4 Compressor I/O Board

4.3.1 Compressor I/O Board Mounting Instructions

1. Tilt the I/O Board as shown in Figure 4-5 Compressor I/O Board Installation in order to engage it into
2. Lower the I/O Board until it snaps into place.
Figure 4-5 Compressor I/O Board Installation
the DIN Rail.
NOTE
M-AP-001-EN Rev. S-9/8/2021 Page 39 of 136