Adjust Focus - Sanyo LNS-W03 Lens Replacement Manual

3
INSTALL THE LENS. (See figure-4)
1. Remove protective caps(front and
back) on the lens.
2. Mount the lens on mounting bracket
of the main cabinet with 4 screws.
Use the screws included with the lens.
Use the driver included with the lens to
fasten the screws.
(After using, keep it for latter use.)
4 INSTALL THE LIGHT-BLOCK SHEET. (See figure-5)
Install the light-block sheet around the lens
as shown in the illustration. Use the sheet
included with the lens.
Make sure the part no. and mark (TOP and
BACK) on Light-Block Sheet and set them
properly.

ADJUST FOCUS

Adjust focus following Focus Adjustment on
page 6.
5
MOUNT THE LENS COVER. (See figure-6)
When in install the both upper and lower
lens covers, install the light-block sheet so
that it should be placed in the guide slot.
(place of the cover plate had been placed.
See figure-2.) If the installation of light-block
sheet is incorrect, it will be the cause of
leakage of light or the dust entering at the
main cabinet.
1. Insert the upper part lens cover and fix
them with screws A (4 screws).
2. Insert the lower part lens cover and fix
them with screws B. (2 screws).
ATTACHED DRIVER
LIGHT-BLOCK SHEET
Type FE1
(Part No. 610 280 2634)
UPPER LENS COVER
A
B
LOWER LENS COVER
-3-
LENS MOUNTING BRACKET
A
Fig-4
Fig-5
Fig-6